Datasheet
4© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 • 864-963-6300 • www.kemet.com A4071_A767 • 2/7/2018
Surface Mount Conductive Polymer Aluminum Solid Electrolytic Capacitors
A767 105°C
Test Method & Performance
Conditions Load Life Test Shelf Life Test
Temperature 105°C 105°C
Test Duration 2,000 hours 168 hours
Ripple Current No ripple current applied No ripple current applied
Voltage
The sum of DC voltage and the peak AC voltage must not exceed the
rated voltage of the capacitor
No voltage applied
Performance The following specications will be satised when the capacitor is restored to 20°C.
Capacitance Change Within ±20% of the initial value
Dissipation Factor Does not exceed 150% of the specied value
ESR Does not exceed 150% of the specied value
Leakage Current Does not exceed specied value
Damp Heat
The following specications will be satised when the capacitor is restored to 20°C
after application of rated voltage for 1,000 hours at 60°C, 90%~95% RH.
Capacitance Change Within ±20% of the initial value
Dissipation Factor Does not exceed 150% of the specied value
ESR Does not exceed 150% of the specied value
Leakage Current Does not exceed specied value
Surge Voltage
(Rated Voltage x 1.15(V))
The following specications will be satised when the capacitor is subjected to 1,000
cycles each consisting of charge with the surge voltages specied at 105°C for 30
seconds through a protective resistor (Rc = 1 kΩ) and discharge for 5 minutes 30
seconds.
Capacitance Change Within ±20% of the initial value
Dissipation Factor Does not exceed 150% of the specied value
ESR Does not exceed 150% of the specied value
Leakage Current Does not exceed specied value
Resistance to Soldering
Heat
Measurement for solder temperature prole at capacitor top and terminal.
Capacitance Change Within ±10% of the initial value
Dissipation Factor Does not exceed 130% of the specied value
ESR Does not exceed 130% of the specied value
Leakage Current Does not exceed specied value