Datasheet

© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard C1086_U2J • 11/8/2018
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
4
Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
U2J Dielectric, 10 – 100 VDC (Commercial & Automotive Grade)
Automotive C-Spec Information
KEMET automotive grade products meet or exceed the requirements outlined by the Automotive Electronics Council.
DetailsregardingtestmethodsandconditionsarereferencedindocumentAEC–Q200,StressTestQualicationforPassive
Components.TheseproductsaresupportedbyaProductChangeNotication(PCN)andProductionPartApprovalProcess
warrant(PPAP).
Automotive products offered through our distribution channel have been assigned an inclusive ordering code C-Spec, “AUTO.”
This C-Spec was developed in order to better serve small and medium-sized companies that prefer an automotive grade
componentwithouttherequirementtosubmitacustomerSourceControlledDrawing(SCD)orspecicationforreviewbya
KEMET engineering specialist. This C-Spec is therefore not intended for use by KEMET OEM automotive customers and are
notgrantedthesame“privileges”asotherautomotiveC-Specs.CustomerPCNapprovalandPPAPrequestlevelsarelimited
(see details below.)
Product Change Noti cation (PCN)
TheKEMETproductchangenoticationsystemisusedtocommunicateprimarilythefollowingtypesofchanges:
 •Product/processchangesthataffectproductform,t,function,and/orreliability
• Changes in manufacturing site
 •Productobsolescence
KEMET Automotive
C-Spec
Customer Noti cation Due To:
Days Prior To
Implementation
Process/Productchange Obsolescence*
KEMET assigned
1
Yes (with approval and sign off) Yes 180 days minimum
AUTO Yes (without approval) Yes 90 days minimum
1
KEMET assigned C-Specs require the submittal of a customer SCD or customer speci cation for review. For additional information contact KEMET.
Production Part Approval Process (PPAP)
ThepurposeoftheProductionPartApprovalProcessis:
• To ensure that supplier can meet the manufacturability and quality requirements for the purchased parts.
 •Toprovidetheevidencethatallcustomerengineeringdesignrecordsandspecicationrequirementsareproperly
understoodandfullledbythemanufacturingorganization.
• To demonstrate that the established manufacturing process has the potential to produce the part.
KEMET Automotive
C-Spec
PPAP (Product Part Approval Process) Level
1 2 3 4 5
KEMET assigned
1
● ● ● ● ●
AUTO
○ ○
1
KEMET assigned C-Specs require the submittal of a customer SCD or customer speci cation for review. For additional information contact KEMET.
●PartnumberspecicPPAPavailable
○ProductfamilyPPAPonly