Datasheet

2© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard C1105_KONNEKT_KC-Link_C0G • 5/20/2020
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Surface Mount Multilayer Ceramic Chip Capacitors (SMD MLCCs)
KC-LINK™ with KONNEKT™ Technology for High-Eciency, High-Density Power Applications (Commercial Grade)
Ordering Information
CKC 33 C 884 K C G L C XXXX
Series
Case Size
(L"x W ")
Specication/
Series
Capacitance
Code (pF)
Capacitance
Tolerance
Rated
Voltage (V)
Dielectric
Subclass
Designation
Termination
Finish
Orientation and
Packaging
(Sux/C-Spec)
CKC =
KC-LINK
33 = 3640 C =
Standard
Two single
digits and
number of
zeros.
K = ±10% C = 500 V
W = 650 V
D = 1,000 V
E = 1,200 V
J = 1,700 V
G =
C0G
L =
KONNEKT
C = 100% matte Sn See
"Packaging
C-Spec
Ordering
Options
Table"
Electrical Parameters/Characteristics
Item Parameters/Characteristics
Operating temperature range −55°C to +150°C
Capacitance change with reference to +25°C
and 0 VDC applied (TCC)
±30 PPM/°C
Aging rate (maximum % capacitance loss/decade hour) 0%
1
Dielectric Withstanding Voltage (DWV)
Rated Voltage DWV
500 V 150% of rated voltage
650 V 130% of rated voltage
≥ 1,000 V 120% of rated voltage
(5±1 seconds and charge/discharge not exceeding 50 mA)
2
Dissipation Factor (DF) Maximum Limit at 25°C
0.1%
3
Insulation Resistance (IR) Minimum Limit at 25°C
1,000 - MΩ - µF or 100 GΩ
(500 VDC applied for 120±5 seconds at 25°C)
1
DWV is the voltage a capacitor can withstand (survive) for a short period of time. It exceeds the nominal and continuous working voltage of the
capacitor.
2
Capacitance and dissipation factor (DF) measured under the following conditions:
1 kHz ±50 Hz and 1.0 ±0.2 V
rms
3
To obtain IR limit, divide MΩ – µF value by the capacitance and compare to GΩ limit. Select the lower of the two limits.