Datasheet

4© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard F3108_PHE844_X1_440-480 • 2/28/2019
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Film Capacitors – Metallized Polypropylene Film EMI Suppression Capacitors
PHE844, Class X1, 440/480 VAC, 105°C
Performance Characteristics
Dielectric Polypropylenelm
Plates Metal layer deposited by evaporation under vacuum
Winding Non-inductive type. Series design.
Leads Tinned wire
Protection Plasticcase,thermosettingresin-lled.Boxmaterialissolvent-resistantandame-retardantaccordingtoUL94V–0.
Rated Voltage V
R
440 VAC 50/60 Hz (ENEC) – 480 VAC 50/60 Hz (UL,cUL)
Capacitance Range 0.10 – 2.2 µF
Capacitance Values E6 series (IEC 60063)
Capacitance Tolerance ±20% standard, ±10% option
Temperature Range -40°Cto105°C
Climatic Category 40/105/56/B IEC 60068-1
Approvals ENEC, UL, cUL
Related Documents EN/IEC 60384-14:2005, UL 60384-14, CAN/CSA E60384-14:09
DissipationFactor(tanδ)
MaximumValuesat+23°C
Frequency C≤0.1μF 0.1µF<C≤1µF C > 1 µF
1 kHz 0.1% 0.1% 0.1%
10 kHz 0.2% 0.4% 0.8%
100 kHz 0.6% - -
Test Voltage Between
Terminals
The 100% screening factory test is carried out at 3,000 VDC. The voltage level is selected to meet the
requirementsinapplicableequipmentstandards.Allelectricalcharacteristicsarecheckedafterthetest.Donot
repeat this test, as there is a risk of damaging the capacitor. KEMET is not liable for any failures if the test has
been repeated.
ResonanceFrequency TabulatedSelf-resonanceFrequenciesf
o
(see Table 1 – Ratings & Part Number Reference)
Insulation Resistance
Measuredat+25°C±5°C,accordingtoIEC60384-2
Minimum Values Between Terminals
C≤0.33μF C>0.33μF
≥30,000MΩ ≥10,000MΩ•µF
In DC Applications Recommendedvoltage≤1,000VDC