Datasheet

7© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard F3064_PME295_Y1_440-480 • 3/15/2019
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Film Capacitors
AC Line EMI Suppression and RC Networks – PME295, Metallized Impregnated Paper, Class Y1, 440 VAC/480 VAC
Soldering Process cont'd
Wave Soldering Recommendations cont'd
1. The table indicates the maximum set-up temperature of the soldering process
Figure 1
Dielectric
Film
Material
Maximum Preheat Temperature
Maximum Peak
Soldering Temperature
Capacitor
Pitch≤10mm
Capacitor
Pitch = 15 mm
Capacitor
Pitch > 15 mm
Capacitor
Pitch≤15mm
Capacitor
Pitch > 15 mm
Polyester 130°C 130°C 130°C 270°C 270°C
Polypropylene 100°C 110°C 130°C 260°C 270°C
Paper 130°C 130°C 140°C 270°C 270°C
Polyphenylene
sulphide
150°C 150°C 160°C 270°C 270°C
2. The maximum temperature measured inside the capacitor: set the temperature so that inside the element the maximum
temperature is below the limit.
Dielectric Film Material
Maximum Temperature
Measured Inside the Element
Polyester 160°C
Polypropylene 110°C
Paper 160°C
Polyphenylene sulphide 160°C
Temperature monitored inside the capacitor.
Selective Soldering Recommendations
Selectivedipsolderingisavariationofreowsoldering.Inthismethod,theprintedcircuitboardwiththrough-hole
componentstobesolderedispreheatedandtransportedoverthesolderbath,asinnormal-owsoldering,withouttouching
thesolder.Whentheboardisoverthebath,itisstopped.Pre-designedsolderpotsareliftedfromthebathwithmolten
solder only at the places of the selected components, and then pressed against the lower surface of the board to solder
the components.
Thetemperatureproleforselectivesolderingissimilartothetemperatureprolefordouble-waveowsolderingoutlinedin
this document. However, instead of two baths, there is only one with a time from 3 to 10 seconds. In selective soldering, the
riskofoverheatingisgreaterthanindouble-waveowsoldering,andgreatcaremustbetakensothatthepartsdo
not overheat.