Datasheet

4© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard F3103_R60 • 7/8/2019
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Film Through-Hole Capacitors – General Purpose Metallized Polyester Film Capacitors
R60, Radial, 10.0 – 37.5 mm Lead Spacing, 63 – 1,000 VDC (Automotive Grade)
Performance Characteristics
Dielectric Polyesterlm(polyethyleneterephthalate)
Plates Metal layer deposited by evaporation under vacum
Winding Non-inductive type
Leads Tinned wire
Protection
Plasticcase,thermosettingresinlled.Boxmaterialissolventresistantandameretardantaccordingto
UL 94.
Related Documents IEC 60384–2
Rated Voltage V
R
(VDC) 50 63 100 160 250 400 630 1000
Rated Voltage V
R
(VAC) 30 40 63 90 160 200 220 250
Capacitance Range (µF) 1.5 – 5.6 0.68 – 100 0.33 – 150 0.22 – 150 0.1 – 68 0.022 – 33 0.0047 – 10 0.001 – 4.7
Capacitance Values E6series(IEC60063)measuredat1kHzand+20±1°C
Capacitance Tolerance ±5%, ±10%, ±20%
Operating Temperature
Range
−55°Cto+105°C
Upperoperatingtemperatureof+125°Cisallowedforamaximumoperatingtimeof1,000hours.
Rated Temperature T
R
+85°C
Voltage Derating Above+85°CDCandACvoltagederatingis1.25%/°C
Climatic Category 55/105/56 IEC 60068–1
Storage Conditions
Storagetime:≤24monthsfromthedatemarkedonthelabelpackage
Averagerelativehumidityperyear≤70%
RH≤85%for30daysrandomlydistributedthroughouttheyear
Dew is absent
Temperature:−40to80°C(see"MaximumHumidityinStorageConditions"graphbelow)
Test Voltage 1.6 x V
R
VDCfor2seconds(betweenterminations)at+25°C±5°C
Capacitance Drift
Maximum3%aftera2yearstorageperiodatatemperatureof+10°Cto+40°Candarelativehumidityof40%
to 60%
Reliability
(Reference MIL–HDBK–217)
Operational life > 200,000 hours
Failurerate≤5FIT,T=+40°C,V=0.5xV
R
Failure criteria: open or short circuit, capacitance change > 10%, DF 2 times the catalog limits,
IR < 0.005 x initial limit
Maximum Pulse Steepness
dV/dt according to Table 1. For peak to peak voltages lower than rated voltage (Vpp <V
R
),thespecieddv/dt
can be multiplied by the factor V
R
/Vpp
TemperatureCoecient +400(±200)ppm/°Cat1kHz
Self Inductance
(Lead Length ~ 2 mm)
Lead Spacing
(mm)
10 15 22.5 27.5 37.5
L (nH) 9 10 18 18 22
Maximum 1 nH per 1 mm lead and capacitor length.