Datasheet

12© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard SE0209_VS • 9/12/2019
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Vibration Sensors – VS Vibration Sensors
Packaging
Part Number Packaging Type Pieces per Inner Box Pieces per Outer Box
VS-JV10A Box 1 100
VS-JV10A-K01 Box 1 10
VS-JV10A-K02 Box 1 10
VS-JV10A-K03 Box 1 10
VS-JV10A-K04 Box 1 10
VS-BV203-B Box 1 100
Handling Precautions
Vibration Sensor VS-JV10A
• To secure the sensor body with screws, use M4 screws with a standard mounting torque (1.5 Nm).
• Tighten the M8 connector with the torque specied for the cable to be used. The specied torque for the standard cable
is 0.4Nm.
• When connecting the connector, align the pins on the sensor and cable, and fully insert the cable before tightening
the screw.
Cable & Connector VSC-100PURS4-M8D-01
• Please tighten the M8 connector with the specied torque (0.4Nm) of a standard cable before use.
• When connecting the connector, align the pins on the sensor and cable, and fully insert the cable before tightening
the screw.
Magnet Base VM-03
• Use a tightening torque 1.5 Nm when screwing the vibration sensor onto the magnet base.
• Vibration measurements undertaken using the magnet base are affected by both the materials and surface conditions of
the attached surface, which changes the output characteristics of the sensor. Please test and conrm operation in the
specic target environment before use.
• Since strong magnets base are used, be careful not to allow your hand to become caught between several magnet bases
or between a magnet base and a metal object.
• Do not place the magnet base close to mobile phones, analog clocks, magnetic cards, magnetic tapes, etc.
This can result in the loss of stored information.
• Be aware that improperly stored magnet bases are dangerous, as they may strongly attract nearby magnets and
metal objects.
Mounting Stud VA-01
• Use a tightening torque 1.5 Nm when screwing the vibration sensor onto the mounting stud.
• Vibration measurements undertaken using the magnet base are affected by both the materials and surface conditions of
the attached surface, which changes the output characteristics of the sensor. Please test and conrm operation in the
specic target environment before use.