Datasheet

2© KEMET Electronics Corporation • KEMET Tower • One East Broward Boulevard SE0209_VS • 9/12/2019
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
Vibration Sensors – VS Vibration Sensors
Ordering Information
VS- J V 10 A -K01
Series
Model
Type
Output
Type
Sensitivity Interface Version Accessories
VS = Vibration
Sensor
B
J
V = Voltage
C = Current
10 = 10 m/s
2
20 = 20 m/s
2
Blank = M8 connector type
3 = Integrated 3m cable type
A
B
Blank = Without accessory
K01 = Cable + magnet + stud for J type sensor
K02 = Cable for J type sensor
K03 = Cable + magnet for J type sensor
K04 = Cable + stud for J type sensor
Environmental Compliance
All KEMET Vibration Sensors are RoHS and REACH Compliant.
Article 33(1) of the REACH Regulation states that manufacturers and importers of articles (products) are required to notify
their customers of the presence of any Substances of Very High Concern (SVHC) in their products exceeding 0.1% by weight
and provide instructions on safe use of the product.
KEMET Corporation reports regarding the Article 33(1) of REACH Regulation as follows:
1. Applicable Product: Vibration Sensors (VS series)
2. Report for the content of REACH SVHC list:
The product(s) above contains a substance by more than 0.1wt% per product weight that was published in the 8th update of
the REACH SVHC substances (December 19, 2012).
3. Regarding the safety of the vibration sensors (Piezoceramic products):
The Piezoceramic that is used in this product becomes ceramic by sintering powder containing PZT as the main ingredient. It
is chemically stable, with minimum risks toward the human body or environment within the intended use of the product. Please
note that risks could occur in the case of inhalation or accidental oral uptake of powder ceramics.
4. Technical product information on the vibration sensors (Piezoceramic products):
The manufacturing technique of the “piezoceramic products” whose main ingredient is Lead Titanium Zirconium Oxide (PZT)
has been established, and there is no alternative material that can exhibit superior performance than PZT at this moment.
Please note that the piezoceramic is listed as an exempt on RoHS (2011/65/EU) AnnexIII (7c.1).
5. The responsibility of piezoceramic manufacturers:
Piezoceramic manufacturers report information regarding PZT containment in their products to the customers to obey the
article 33 of the REACH regulation