Operation Manual

X8 MIG WELDER 2.4 Operation
Selecting memory channel
You can select a memory channel through Control Pad, wire feeder display or gun remote control.
Proceed as follows:
1.
To select a memory channel through Control Pad or wire feeder display:
a) Press the Channel button.
b) Scroll with the right knob to a memory channel.
The selection activates immediately.
2.
To select a memory channel through the gun remote control, see Gun remote control on page 99.
Saving modified memory channel settings
Proceed as follows:
1.
To save modified settings in Control Pad or on the wire feeder display over the current settings of a
memory channel:
a) In the Welding view, press and hold the Channel button.
OR
2.
To save modified settings in Control Pad over the current settings of a memory channel:
a) Press Channel.
b) Open Actions.
c) Select Save changes and press the green button.
3.
To save modified settings in Control Pad on a different memory channel:
a) Press Channel.
b) Open Actions.
c) Select Save to and press the green button.
OPERATING MANUAL | EN 111
©
KEMPPI | 2018-09-28