Operation Manual

X8 MIG WELDER 2.4 Operation
To fine tune the voltage while welding, in the Control Pad's Welding view, turn the right knob.
Figure 35: WiseThin+ Welding view
When using WiseThin+, depending on the welding program, you can adjust the following welding
parameters through Settings > Parameters:
• Wire feed speed
• min: adjusts the minimum set value for wire feed speed
• max: adjusts the maximum set value for wire feed speed
• Fine tuning: adjusts the voltage (arc length).
• Dynamics: -10...+10. Adjusts the short circuit behavior. On the minus side, the arc is softer (less spatter).
On the plus side, the arc is harder (the arc is more stable).
• StartPower: -30...+30. Adjusts the power level for arc ignition.
• StartLevel: -30...+30. Finetunes the arc length for arc ignition.
• StopPower: -30...+30. Adjusts the power level for arc stop.
Wise features
Kemppi Wise features improve the quality of welds. For more information on Wise products, visit
www.kemppi.com.
Introduction to WiseFusion
The WiseFusion welding function enables adaptive arc length control, which keeps the arc optimally short
and focused. WiseFusion increases the welding speed and penetration and decreases heat input. WiseFusion
can be used throughout the power range (short arc, globular arc, spray arc and pulsed arc). WiseFusion is
compatible with 1-MIG, Pulse and DPulse welding processes.
Using WiseFusion
+
OPERATING MANUAL | EN 127
©
KEMPPI | 2018-09-28