Operation Manual

X8 MIG WELDER 2.4 Operation
machines connected to WeldEye. If no Internet connection is available, it is possible transfer the dWPSs on a
USB stick. The user can then view, activate and select the dWPSs with Control Pad. It is also possible to select
dWPSs through the wire feeder display or the welding gun remote control.
When a dWPS is selected, the welding system settings are automatically adjusted accordingly. This decreases
the possibility of errors and makes the work faster and easier as manual adjustments are not necessary.
However, fine tuning of the parameters is still possible. The user can see the detailed information about the
dWPS as well as the related joint design and welding sequence drawings on the Control Pad. No paper copy
of the WPS is needed. As the same dWPSs can be automatically transferred to several welding machines, it is
easy to have the same settings in all the machines.
Figure 49: dWPS process
For more information on WeldEye, see Introduction to WeldEye.
Activating WPS
Proceed as follows:
1.
Go to the View menu (in the Welding view, press the Menu button) and select WPS.
If no WPS is currently active, the following view opens:
OPERATING MANUAL | EN 138
©
KEMPPI | 2018-09-28