Operation Manual

X8 MIG WELDER 2.4 Operation
If the WPS includes several passes, select the pass in Active pass. See Selecting WPS pass in WPS view
on page 141.
5.
Press a view button to leave the WPS view.
Note:
You can also change WPS or the pass in Channel view. See Selecting WPS or pass in Channel
view on page 143.
Selecting WPS pass in WPS view
Proceed as follows:
1.
Go to the View menu > WPS.
Control Pad shows the active WPS in the WPS view.
OPERATING MANUAL | EN 141
©
KEMPPI | 2018-09-28