Operation Manual

X8 MIG WELDER 2.4 Operation
To take WiseSteel into use, select Settings > Wise features > WiseSteel.
To adjust the welding power/wire feed speed while welding, in the Control Pad's Welding view, turn the left
knob.
To fine tune heat output while welding, in the Control Pad's Welding view, turn the right knob.
Figure 37: WiseSteel Welding view
Note:
The wire feed speed / current indicator shows the arc range:
1. Short arc
2. Globular arc
3. Spray arc
The adjustment method is different for each range.
Introduction to WisePenetration+
In standard MIG/MAG welding, changes in stick-out length cause welding current to fluctuate.
WisePenetration+ maintains constant welding current by controlling the wire feed speed according to the
stick-out length. This ensures stable and effective penetration and prevents burn through. WisePenetration
+ also adjusts the voltage adaptively, which keeps the arc focused and optimally short. WisePenetration+
enables welding with Reduced Gap Technolology (RGT) and is compatible with 1-MIG and Pulse welding
processes.
Using WisePenetration+
To take WisePenetration+ into use, select Settings > Wise features > WisePenetration+.
To adjust the welding current, in the Control Pad's Welding view, turn the left knob.
OPERATING MANUAL | EN 129
©
KEMPPI | 2018-09-28