Operation Manual

X8 MIG WELDER 2.4 Operation
To fine tune heat output, in the Control Pad's Welding view, turn the right knob.
Figure 38: WisePenetration+ Welding view
MMA welding
5
To use X8 MIG Welder in MMA mode, in Control Pad:
1. Select Settings > Mode > MMA.
2. Select the MMA welding program. An all-around MMA welding program pre-installed.
Note:
X8 MIG Welder features a voltage reduction device (VRD). When the welding machine is on but the
welding arc is not ignited, the welding machine is on open circuit voltage (50 V). If the VRD is in use,
it keeps the open circuit voltage on a lower, pre-set level (20 V/12 V).
For MMA welding, both DC+ and DC- mode are available.
To adjust the welding current while welding, in the Control Pad's Welding view, turn the left knob.
To adjust the dynamics while welding, in the Control Pad's Welding view, turn the right knob.
OPERATING MANUAL | EN 130
©
KEMPPI | 2018-09-28