Product Manual

768 E. North Street, P. O. Box 9320, Akron, Ohio 44305; Phone: [phone], Fax: [phone]
Website: www.kentool.com E-Mail: [e-mail]
Super Serpent ™ T2006 #35448 Demount Tool
With the center well of the wheel
resting on the second bead, place the
notched end (notches down) under
the bead at the top of the wheel.
Push the tool between the bead and
the rim until the second notch grabs
the wheel. You should hear 2 clicks
as the tool passes over the wheel.
The tool will push against the
sidewall of the tire.
While holding the end of the tool,
STEP BACK
as you allow the
tire/wheel assembly to fall.
IF THE TIRE DOES NOT
RELEASE, THE TOOL WILL BE
JERKED FROM THE
OPERATOR’S HAND. KEEP
LEGS AND FEET CLEAR OF
THIS AREA TO AVOID INJURY.
RELEASE THE TOOL IF
EXCESSIVE LOAD IS BEING
APPLIED.
Stay clear of the assembly as it falls. Tire is fully demounted.
3
Instruction Manual
Part No. 35447-98
DEMOUNTING A SUPER SINGLE - Continued
For additional information on the Ken-Tool, Oldforge, Carica and Hard Cap lines of products, see our
website at www.kentool.com.
The following items are included in the 35446 Super Serpent Set
1 = 35447 Mount Tool
1 - 35448 Demount Tool
2 - 31710 Bead Holding Device
1 - 31810 Leather Rim Protector