Owner manual

DISCLAIMER: Kendall Howard LLC. endeavors to make this manual accurate and com-

plete. However, Kendall Howard LLC makes no representations or warranties of any

kind, expressed or implied, about whether the use of products contained herein would

infringe any rights or the correctness, accuracy or reliability of the information contained

herein or that said information covers all details, conditions or variations. The information

herein does not provide for every possible contingency in connection with the installation

or use of the product(s). The information contained in this document is subject to change

without notice or obligation. Kendall Howard LLC assumes no responsibility for the

accuracy, completeness or reliability of the information contained in this document. Any

reliance place d on the information is there fore strictly at you r own risk.

For details about product warranty, please visit www.kendallhoward.com

Assembly - Step 4:

a. Secure female Hinges to the Cable Enclosure Bottom with the

M5x10 Screws. Make sure the hole openings are face to-

wards each other.

b. Secure 1 Male Hinge to Cable Enclosure Door Bottom with

the M5x10 Screws. Insert should be facing to the outsides of

the door

c. Insert the installed male hinge into the female hinge. Take

the remaining male hinge and insert into the opposing female

hinge and secure to the door with the M5x10 Screws

Instructions / Directions

Training Table Cable Management Enclosure

# 5500-3-100-72

INN O VATOR S IN PR OD U CT D ES IGN

w w w . k e n d a l l h o w a r d . c o m

A d d r e s s : 1 0 1 5 2 L i b e r t y L a n e

C h i s a g o C i t y , M i n n e s o t a , 5 5 0 1 3

U n i t e d S t a t e s o f A m e r i c a

P h o n e : 651- 213- 1333

F a x : 800- 418- 6897

PAGE 1
Assembly - Step 4: Instructions / Directions Training Table Cable Management Enclosure # 5500-3-100-72 a. Secure female Hinges to the Cable Enclosure Bottom with the M5x10 Screws. Make sure the hole openings are face towards each other. b. Secure 1 Male Hinge to Cable Enclosure Door Bottom with the M5x10 Screws. Insert should be facing to the outsides of the door c. Insert the installed male hinge . into the female hinge.
PAGE 2
Tools Needed: Assembly - Step 2: Screw Driver Included: (1x) Bottom (1x) Right End (1x) Left End (1x) Door (2x) Lock Base (11x) 1/4-20 Screw (2x) Male Hinge (8x) M5x10 Screw a. Detach the modesty panel from the leg kit b. Remove screws from the rear leg kit that fasten it to the table top c. Slide the Cable Enclosure around the modesty panel d. Re insert screws securing the modesty panel and cable enclosure to the leg kit.