SINGLE RIDE-UP SRL* STAND-UP™ TRAILER INSTRUCTIONS *Suspension Reactive Loading KENDON INDUSTRIES, INC. 3711 East La Palma Avenue Anaheim, CA 92806 USA Tel 714-630-7144 • Fax 714-630-7132 www.KendonUSA.com Rev.
714-630-7144 www.KendonUSA.com WARNING: Serious injury, death and/or property damage could result through improper use of this product, including crushing or severing type injuries. WARNING: Thoroughly read and understand all instructions and owner’s manual(s) before using the trailer. WARNING: For Adult Use Only. Keep children away from trailer at all times.
714-630-7144 www.KendonUSA.com in serious injury and or property damage. Load and unload at your own risk. WARNING: Ramps cannot be interchanged. Ramps are clearly marked. Right and Left ramps are not constructed to hold the weight of a vehicle and should never be used as a loading ramp for any vehicle. Right and Left ramps are for rider footing during the loading and unloading process.
714-630-7144 www.KendonUSA.com LOADING Properly attach the loading ramps as per this manual’s instructions. The motorcycle must be loaded only on the center loading ramp. Ensure the wheel chock on the rail is in the open position (pg. 10). LOADING RAMPS How to use the ramps on your Kendon Ride-Up Single SRL Trailer: Insert the ramp hook as shown below between the tubular rails on the rear folding section of the trailer.
714-630-7144 www.KendonUSA.com Kendon Ride-Up Single SRL Trailer Instructions Congratulations on your purchase of a Kendon Stand-Up™ Single Rail RideUp Motorcycle Trailer with SRL. Safety is our number one concern. Before using this product, please take the time to completely read these specific RideUp Single trailer instructions and familiarize yourself thoroughly with the parts on your new Kendon Ride-Up Single SRL Trailer.
14-630-7144 www.KendonUSA.com Most Common Hazards • • • • • • Failure to read instructions. Loss of balance while loading. Slippery surfaces (wet, snow and/or icy surfaces are dangerous to load and unload on). Trailer not properly connected to tow vehicle. This is a common and expensive error causing the trailer to tip up and run into the back of your tow vehicle and also causing a possible fall in the loading process. This can also cause expensive damage to tow vehicle.
714-630-7144 www.KendonUSA.com Usage Instructions for Kendon Ride-Up Single SRL Trailer Thoroughly read and understand these instructions and the attached Owner’s Manual for Kendon Stand-Up™ Trailers. Attach the Trailer to Tow Vehicle making sure the coupler completely engages the ball and that the coupler latch is locked down. Refer to the diagram below for an illustration of the coupler latch in the closed position.
714-630-7144 www.KendonUSA.
714-630-7144 www.KendonUSA.com There are two (2) Ramp Pins and they are both the same. One (1) ramp pin unites the ramps at the top and one (1) unites the ramps at the bottom creating one connected loading platform. Hook each ramp to the rear folding section of the trailer going in the following order: Left, Center and Right ramp. Each Ramp Hook needs to face up like a spoon and the expanded metal deck needs to be on the top of the ramp (pointing up towards the sky).
714-630-7144 www.KendonUSA.com Properly Installed Top Ramp Pin Slide the second ramp pin through the ramps following the same process. Properly Installed Bottom Ramp Pin NEVER USE RAMPS WITHOUT BOTH RAMP PINS FULLY ENGAGED AS INSTRUCTED AS THIS WILL CAUSE THE RAMP PLATFORM TO BE UNSTABLE. The center ramp will support the weight of a heavy weight motorcycle with an average weight adult rider if you choose to ride the bike up or down.
714-630-7144 www.KendonUSA.com Proper Loading & Securing of Vehicle Front Wheel Chock Position must be flipped into the “open” or “load” position with the rear section of the wheel chock flat on the trailer rail. Failure to have the front wheel chock in the correct position will cause the front wheel to hit an obstacle during the loading process resulting in a possible loss of balance and or fall. Ensure the wheel chock is in the open position before the motorcycle is loaded up on the trailer platform.
714-630-7144 www.KendonUSA.com Proper Ramp Storage Before the ramp pins can be slid out, you will need to depress the lock button at one end of each pin. Once the lock button is pressed, you can slide the ramp pins out. Repeat this procedure for both top and bottom ramp pins. Detach the ramps from the rear section of the trailer. Attach ramps back on the trailer in their original positions being careful that side ramps do not overlap the rear folding section of the trailer.
714-630-7144 www.KendonUSA.com One (1) ramp pin can be stored on the side of either one of the side ramps. Make sure to slide the ramp pins all the way through so that the lock button is popped out on the opposite end of insertion point. Position the open diamond shape of the expanded metal on the ramp with the attachment points on the trailer. Attach T-Bolts through the ramp and tighten. Ramps must be properly mounted on the trailer with supplied mounting hardware firmly tightened down.
714-630-7144 www.KendonUSA.com Unloading Attach ramps as instructed on pg. 6. Remove all four (4) tie-downs from vehicle. The motorcycle will not easily roll back to unload due to the design and function of the front wheel chock. Tips and Technique When the trailer is loaded, the front wheel chock captures the front wheel of the motorcycle. To unload, you have to get the wheel chock over its center point and then it will release.
714-630-7144 www.KendonUSA.com Care and Maintenance of Ride-Up Single SRL Trailer Keep ramp pins and ramp pin locating tubes clean. A light lubricant (silicone spray, WD 40 or equivalent) on the ramp pins will keep them working smoothly. Ramp Pins are plated to prevent oxidation but an extra step of care will prevent pins from becoming hard to insert or remove due to any dirt and/or oxidation.
714-630-7144 www.KendonUSA.
714-630-7144 www.KendonUSA.com WARNING: Serious injury, death and/or property damage could result through improper use of this product, including crushing or severing type injuries. WARNING: Thoroughly read and understand all instructions and owner’s manual(s) before using the trailer. WARNING: For Adult Use Only. Keep children away from trailer at all times.
714-630-7144 www.KendonUSA.com in serious injury and or property damage. Load and unload at your own risk. WARNING: Ramps cannot be interchanged. Ramps are clearly marked. Right and Left ramps are not constructed to hold the weight of a vehicle and should never be used as a loading ramp for any vehicle. Right and Left ramps are for rider footing during the loading and unloading process.
714-630-7144 www.KendonUSA.com Stand-Up™ Trailer Parts & Accessories Dowco Trailer Cover DOWCO107 LED Tail Light Kit LEDTLK Trailer Jack Stand SU207 Aluminum Wheel and Radial Tire Kit HPRTWK13 Crank Down Swivel Jack Stand TSJS Tie-Downs TDK107 Single Stone Guard SG107 Single Utility Boxes BX107 13” Spare Tire BB206N Visit us at www.KendonUSA.com for product updates, new products, and support.