User Guide

ManualsBrandsKenko ManualsOtherMVH-2D

Kenko

INNOVATIVE STRONG PAN-TILT HEAD

MVH-2D

INSTRACTION MANUAL

Kenko Co., Ltd.

SPECIFICATIONS

Mounting: ------------------------ Horizontal and upright or inverted position

Operating temperature: --------- -10ºCto 45ºC

Dimensions: --------------------- 90w X 144H X 106D mm

Weight: --------------------------- 1.45kg

Power Source -------------------- DC12V 270mA max. (8 X AA size penlight batteries)

Pan movement: ------------------ -150º to +150º in horizontal plane

Tilt movement: ------------------ -30º to +30º in vertical plane

Pan speed: ----------------------- 2.0º/sec. To 6.5º/sec. (Variable)

Tilt speed: ----------------------- 0.7º/sec. To 2.2º/sec. (Variable)

Maximum Load: ---------------- 5.0kg in upright position

3.0kg in inverted position

Maximum Cable length: ------- 7m (200m by extending control cable)

Mounting Brackets: ------------- PT-M2D Ceiling Mount Plate,

WH-1, WH-2, WH-4, PT-W3 Wall Mounts (Option)

Summary of content (4 pages)

PAGE 1
SPECIFICATIONS Kenko INNOVATIVE STRONG PAN-TILT HEAD MVH-2D INSTRACTION MANUAL Kenko Co., Ltd. Mounting: -----------------------Operating temperature: --------Dimensions: --------------------Weight: --------------------------Power Source -------------------Pan movement: -----------------Tilt movement: -----------------Pan speed: ----------------------Tilt speed: ----------------------Maximum Load: ---------------- Horizontal and upright or inverted position -10ºCto 45ºC 90w X 144H X 106D mm 1.
PAGE 2
Specialty 1. PAN-TILT HEAD is set on the tripod and use for Video camera with wired remote control. 2. Pan (vertical) and Tilt (horizontal) is possible to control and also possible pan and Tilt same time. Possible to adjust speed variable. Notice for use 1. 2. 3. 4. 5. 6. 7. Must be fastened to mounting surface. Keep dry. Body must be level. When not level function is not maximized. Put in plastic bag when boxed in foam polystyrene. Don’t drop and give shock. Don’t dismantle.
PAGE 3
NAME OF PARTS INSTRCTION (1) Battery cover screw 1.PUT BATTRY Type: AA Battery 8pces (Option). • Loosen Battery cover fix screw (1) Battery box (2) take out. • Put Battery with care + & - in to Battery box (2) Battery is each side 4pces. • Put Battery box cover (3) to Battery box (2) and install Battery cover screw (1). • Battery box cover (3) slide to Battery box holder (4).
PAGE 4
3.SET CAMERA Camera direction is same as diagram. Balance of camera and lens must be center and tight screw. Screw position is possible to slide. Attention! This unit can hold Max.5kg camera (balance height 6cm). Not in balance will diminimize functions. OPERATION Power switch (13) ON • Speed control Speed control lever (11) slid to left be low Right is High speed. Not possible to adjust Pan and Tilt separately. Attention! Tilt speed will be change depend on weight of camera or direction.