E L ! T E Automatic Washers with CALYPSO '= Wash Motion Lavadoras autom&ticas de lavado CALYPSO Laveuses 3955675A TM automatiques de lavage CALYPSO con movimiento & mouvement TM Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. Sears Canada, Inc., Toronto, Ontario, Canada M5B 2B8 www.sears.com www.sears.
TABLE OF CONTENTS SERVICE SERVICE .......................................................................................... 2 WARRANTY ..................................................................................... 3 WASHER SAFETY ........................................................................... 4 INSTALLATION REQUIREMENTS ................................................ 5 Tools and Parts ............................................................................
Limited Two-Year Warranty Electronic Control Board Your purchase has added value because you can depend on Sears HomeCentral ® for service. With over 2,400 Service Technicians and access to over 900,000 parts and accessories, we have the tools, parts, knowledge and skills to back our pledge: We Service What We Sell. Sears Maintenance Agreements Your Kenmore ® appliance is designed, manufactured and tested to provide years of dependable operation.
WASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This symbol alerts you to potential hazards that can kill or hurt you and others. All follow the safety alert symbol and either the word "DANGER" or Thissafety is themessages safety alertwillsymbol. "WARNING." These words mean: You can be killed or seriously injured if you don't immediately follow instructions.
INSTALLATION REQUIREMENTS Parts listed are available from your local Sears store or Sears Service Centec Please reference the service numbers located on the back page of this manual, Assemble the necessary tools and supplies before beginning the washer installation. The parts supplied are in the washer basket, Do not put the expanded foam plug back into the washer. Tools needed for connecting water inlet hoses the drain • Pliers that open to 19/16in. (3.
Recessed area or closet installation The dimensions shown are for the recommended spacing allowed, except the closet door ventilation openings. The dimensions shown for the closet door ventilation openings are the minimum required. The top of the standpipe must be at least 39 in. (99 cm) high and no higher than 96 in. (2.4 m) from the bottom of the washer. 2 Laundry tub drain system (view 1) The laundry tub needs a minimum 20 gal. (76 L) capacity. The top of the laundry tub must be at least 39 in.
• Do not ground to a gas pipe. • Check with a qualified electrician if you are not sure the washer is properly grounded. • Do not have a fuse in the neutral or ground circuit. 1. 2. 3. 4. 3 prong grounding plug 3 prong grounding-type outlet Ground prong Power ,supply cord GROUNDING INSTALLATION INSTRUCTIONS Install the rear self-adjusting feet 1. To prevent floor damage, set the washer onto cardboard. 2. Move the washer to within approximately final location. 3.
Proper connection ofthedrainhoseprotects yourfloorsfrom damage duetowaterleakage. Carefully readandfollowthese instructions. Thedrainhoseisconnected toyourwasher andisstoredinside ofthewasher cabinet. 1. Insert a new flat washer (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings. Remove drain hose from washer cabinet Gently pull the corrugated drain hose out of the washer from the top of the hose. Continue to pull the hose until the end emerges.
7. Attach the hose with the red coupling to the HOT water (right) inlet valve. Screw on coupling by hand until seated on the washer. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not over[ighten. Damage to the valves can result. Check for leaks 8. Turn on the water faucets and check for leaks. A small amount of water might enter the washer. You will drain this later. Properly leveling your washer prevents excessive noise and vibration.
6. Check forleaksaround faucets andinlethoses. SENSOR SMART" Electronic Controls SENSOR SMART electronic controls are easy to use whether you are a beginner or an "expert." TRIPLE SMART Dispensers The TRIPLE SMART dispensers make your washer truly automatic. It is unnecessary for you to return to the washer during the cycle to add detergent, bleach, or fabric softener. TM Laundry products are diluted with fresh water and added to the load at the proper time in the wash cycle.
WASHER USE 2. Pour measured powdered or liquid detergent detergent dispenser. into the d For best performance use with High Efficiency detergents. The package for this type of detergent will be marked "HE" or "High Efficiency." The new wash action of the CALYPSO TM system along with less water, could create too much sudsing with a regular detergent. HE detergents such as TIDEC_HEare made to produce the right amount of suds for the best performance.
4. Pour measured liquid fabric softener into the fabric softener dispenser, if desired. Use these pads to choose the right wash cycle for the type of fabrics you are washing. SELIE_I"CYCLE • Do not overfill. The dispenser holds 3 oz (94 mL), or a capful of fabric softener. • The fabric softener is dispensed in the final rinse. • Do not spill or drip any fabric softener on the clothes.
ULTRA HANDWASH Use this cycle to get 7 to 11 minutes of wash time for garments labeled "Hand Wash" and special care items. Gentle cleaning starts with a continuous spray of water and detergent mixture as the load is spun at extra-low speed. This lasts for about one minute and is followed by a brief period of extra-low wash action. Low/medium spin speed helps reduce wrinkling. The preset cycle wash time is 7 minutes.
Rinses Rinsing is accomplished in the same manner as washing. Fresh water is added to a slow spinning load. Then the load moves through the spray rinses. The water is then drained away and the rinsing process is repeated. The number of rinses varies depending on the cycle. • During the last rinse, fabric softener is dispensed bottom of the tub and applied to the load. STAIN TREAT may be selected as an option with other cycles. See table for details.
Modifiers allow you to further customize your cycles and save energy. WASH/RINSE TEMP Select a water temperature based on the type of load you are washing. Use the warmest water safe for fabrics. Follow garment label instructions. WASH TIME Wash Time is preset for each wash cycle. (See "Preset Cycle Settings" in "Cycles.") As you press WASH TIME pad, the cycle time (minutes) will increase or decrease in the ESTIMATED TIME REMAINING display and a different WASH TIME light will glow.
Adjustable END OF CYCLE SIGNAL A tone will sound at the end of the cycle. The sound level of this tone can be adjusted by pressing END OF CYCLE SIGNAL. The volume of tone you will hear at the end of the cycle will sound as the pads are pressed. OHIGH olaf OOFF LAUNDRY TIPS Preparing clothes for washing Follow these recommendations to help you prolong the life of your garments. • Close zippers, snaps, and hooks to avoid snagging other items.
WASHER CARE Cleaning the exterior Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach• Occasionally wipe the outside of your washer to keep it looking new. Cleaning the interior To clean your washer interior, add 1 cup (250 mL) of chlorine bleach and 1 scoop or cap full of detergent into your dispenser, and run the washer through the NORMAL cycle using hot water. Repeat this process if necessary• NOTE: Remove any hard water deposits using only cleaners labeled as washer safe.
• TROUBLESHOOTING Checkthe following: ,s the power cord plugged into a grounded 3 prong outlet? Is there power at the plug? Check electrical source or call electrician. First try the solutions suggested here and possibly avoid the cost of a service call... Are the hot and cold water faucets turned on? Is the water inlet hose kinked? Washer displaying code messages. If any of these codes continue to occur, call for service.
Washer continues stuck • to fill or drain, or the cycle seems Dispensers clogged Are the laundry Add the correct chlorine bleach liquid color-safe use the chlorine Does the drain hose fit too tightly in the standpipe, or is it taped to the standpipe? The drain hose should be loose yet fit securely. Do not seal the drain hose with tape. The hose needs an air gap. (See "Installation Instructions.
Did you properly sort the load? Sort dark clothes from whites and lights. Garment Did you unload the washer promptly? To avoid dye transfer, unload the washer as soon as it stops. • following: Were strings and sashes tied to prevent tangling? in a low speed cycle? Did you add detergent, chlorine bleach or fabric softener too late in the cycle? Detergent and chlorine bleach should be added before starting the washer. Fabric softener should be added before the rinse status light is lit.
2. OPTIONS PREWASH FOR BEST WASH PERFORMANCE USE A HIGH EFFICIENCY / LOW SUDSING DETERGENT. 1. SELECT CYCLE Select the cycle according to the fabric type being washed. Press START, if OPTIONS and MODIFIERS are the desired settings. HEAVY DUTY For sturdy fabrics and heavy soil. Deep cleans ground-in dirt on work clothes and play wear RINSE/SPIN JEANS/COLORS For dark colored cotton items that may run or fade. Reduces fading of dark colored items like denim jeans and casual cottons.
Your Home SEARS @Registered Tr ed emar kf _Tradema rk/_Se trice Mark of Sears, Roebuck and Co., used under licensee by Sears Canada. CALYPSO is a trademark of Whirlpool U.S.A., used under licensee by Sears, Roebuck and Co. and Sears Canada. _CATALYST is a registered trademark of Whirlpool U.S.A., used under licensee by Sears, Roebuck and Co. and Sears Canada. @TIDE is a registered trademark of The Procter & Gamble Company. @Marca RegistradaF_Marca de F#_brica/_Marca de Servico de Sears, Roebuck and Co.