Manual

E L ! T E
TiPS FOR BEST ELECTRIC DRYER PERFORMANCE
SeeInstallationInstructionsfor moredetailedinformation.
Not fordirectwireinstallations.
Oasis
Clean,
correct
venting
A level
dryer
Fire Hazard
Use a heavy metal vent,
Do not use a plastic vent,
Do not use a metal foil vent.
Failure to follow these instructions can result in death or fire.
Fire Hazard
Cover unused exhaust hole with the following kit:
8212503
Contact your local dealer.
Failure to follow these instructions can result in death, fire,
electrical shock, or serious injury.
Existing vent should be cleaned before connecting dryer and then every two
years for best performance.
Replace plastic vent with rigid
metal or flexible metal vent.
Vent should be 4" (10.16 cm) wide. Use clamps to seal all joints. Make the vent as short as possible
Do not use duct tape or screws, with the fewest number of turns.
If using existing vent, remove lint Remove lint from hood. Flapper
from the entire length of vent. or louvers should move freely.
Use the Vent System Chart below to determine type of vent material and hood
combination acceptable to use.
Vent system chart
.ombe,o.00oto,nso,elbows
0 Rigid metal 84 it (20 m) 5811 (17.7 m)
Rigid metal 54 ft (16.8 m) 48 ft (14.8m)
23 ft (7 m)
1
Flexible metal 31 ft (9.4 m)
Rigid metal 44 ft (13.4 m) 38 ft (11.8m)
2 Flexible metal 27 ft (8.2 m) ;;19ft (8.8 m)
29 ft (8.8 m)
17ft (8.2 m)
21 ft (8.4 m)
15ft (4.8 m)
O
Cold water inlet hose
to the washer.
Check that all four legs are
installed.
Use a wrench to finish turning the Be sure dryer is level side to side Adjust the legs as needed.
legs until the diamond mark is no and front to back.
longer visible.
Proper
electrical
supply
for dryer
W10035726A
© 2007 Sears Brands, LLC
Fire Hazard
Use a new UL listed 30 amp power supply cord.
Use a UL listed strain relief.
Disconnect power before making electrical connections.
Connect neutral wire (white or center wire) to center terminal
(silver).
Ground wire (green or bare wire) must be connected to
green ground connector.
Connect remaining 2 supply wires to remaining
2 terminals (gold),
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or electrical shock.
Disconnect power before making electrical connections. An electric dryer requires a 240 volt electrical
supply. Without the correct electrical supply, your dryer may tumble clothes, but will not heat to dry the
clothes. For more information, see Installation Instructions.
Check your outlet to determine ...or 4-wire 30-amp power supply Use a UL listed strain relief and
whether you should use a new UL cord. make sure it is tightened.
listed 3 wire...
Electric dryers use 2 household fuses or breakers. The drum may be turning, but
you may not have heat if one of the fuses has blown, or if one of the circuit
breakers has tripped.
® TM SM
Registered Trademark / Trademark / Service Mark of Sears Brands, LLC
Connect to cold water supply.
Plug into the outlet.
Clean the lint screen
before every load.
10/07
Printed in U.S.A.