Manual

Install Battery
Unscrew the Electronic Igniter Cap. Install Battery into the Igniter with the positive (+) end out. Screw
the cap back into place.
From the inside of the cabinet, feed the power cord for the Grill Lights through the hole in the left
cabinet side.
Battery
(Size AA)
Qty: 1
Place and Secure LP Cylinder into the Cabine
Rotate the LP Cylinder Tray Latch on the left front corner of the tray counterclockwise to release the
tray lock. Slide the tray out of the cabinet by pulling on the Tray Handle (Inset 1).
Unscrew the Wing Bolt on the back of the LP Cylinder Tray (Inset 2). Place a leak-tested LP Cylinder
into the tray. Make sure the cylinder valve faces the right side of the cabinet. Secure the LP Cylinder
into the tray by tightening the Wing Bolt on the back of the tray.
Slide the LP Cylinder Tray back into the cabinet and lock in place by rotating the LP Cylinder Tray
Latch clockwise (Inset 3).
Be sure the LP Cylinder Valve is OFF by turning the hand wheel clockwise until it stops. Ensure all Burner
Control Knobs are in the OFF position. Remove the safety cap from the LP Cylinder Valve. Center the
nipple of the Regulator into the Cylinder Valve and attach to the tank by turning the black nut
clockwise until it stops (Inset 4).
Note: Hand tighten only. Do not use a wrench. Do not attempt to light your grill at this time.
Inset 1
Inset 2
Inset 3
Inset 4
24