Manual

Trouble Shooting Push and Turn Electronic Ignition
No sparks appear at
any electrodes when
burner control knobs
are turned to SHi;
no noise can be
heard from the
electronic igniter
module
No sparks appear at
any electrodes when
burner control knobs
are turned to SHi;
noise can be heard
coming from the
electronic igniter
module
Sparks are present at
some but not all
electrodes; spark is
weak
• Battery not installed properly
• Dead battery
• Battery cap not installed
properly
• Faulty ignition module
Output wires are not
connected
Electrode tip not in proper
location
• Weak battery
• Some output wires are not
connected
Arcing to grill away from
burners
• Electrodes are wet
• Electrodes are dirty
• Electrodes are cracked or
broken
• Make sure "+" end is facing out.
• Replace with new alkaline battery.
• Check to make sure battery cap is fully engaged with
battery and screwed onto ignition module squarely.
• Replace electronic igniter module.
• Remove all output wires at electronic ignition module
and electrodes and reconnect. Ensure connections are
tight.
Main Burners:
• Tip of electrode should be pointing toward gas port
opening on burner. The distance should be 1/8" to 3/16".
Adjust if necessary.
Rotisserie Burner/Side Burner:
• Tip of electrode should be pointing toward ceramic top
on burner. The distance should be 1/8" to 3/16". Adjust if
necessary.
• Replace with new alkaline battery.
• Remove output wires at electronic ignition module and
electrodes that are not sparking and reconnect. Ensure
connections are tight.
• If possible, observe grill in dark location. Operate
ignition system and look for arcing between output wires
and grill frame. Replace wires if arcing seen.
• Use paper towel to remove moisture.
• Clean electrodes with rubbing alcohol
• Replace electrodes
28