Installation guide

Installation Instructions
STEP 2 | ADJUST LEVELING LEGS
* Move the dishwasher close to the installation location and
lay it on its back.
Adjust to
Installation
Height
Figure H
+ Measure installation height and dishwasher height. Extend
leveling legs out from the dishwasher base, 1/4" less than
installation height.
STEP 3_ | REMOVE TOEKICK
* Remove the 4 toekick screws. Lift off the 2 piece toekick.
Remove
4 Toekick
Figure J
STEP 4 | INSTALL 90° ELBOW
« Wrap 90° elbow with thread seal tape.
* Install a 90° elbow onto the water valve.
C Valve
Q Bracket
Thread
Figure L Seal Tape
* Do not over tighten 90° elbow, water valve bracket could
bend or water valve fitting could break.
* Position the end of the elbow to face the rear of the
dishwasher.