Owners manual

18
CAUTION:
d. Reverse the hinge and the hinge bracket at the
bottom of the cabinet. Remove the two screws
from the hinge bracket at bottom right and remove
the hinge bracket.
Remove the lower of the two screws
behind the hinge bracket. Do NOT
remove the upper screw behind the
hinge bracket. Set the parts aside.
e. Remove the three screws on the
hinge at bottom left. Remove the
hinge and reinstall it on the right
side. The top screw occupies the
hole where you removed the screw
behind the hinge bracket in step d.
f. Install the hinge bracket removed in
step d on the bottom left side, fi rst installing one
screw behind the hinge bracket.
On the Door:
4
Lift off the door cover.
With the door laid inside facing up on a protected
surface, remove the 12 screws on the inside of the
door. Carefully lift off the door cover with the help
of a small flat-blade screwdriver inserted in the
upper corner (circled below).
The edges of the door cover may be sharp. Take care
when handling, or wear gloves to avoid injury.
5
Switch the door strike and the blank cover.
Remove the four screws on the door cover that secure
the door strike and the blank cover.
Switch the door strike and the blank cover, installing
them on the opposite sides from which they were
removed.
Gently pry out the hole plug on the
side of the door cover and install it
in the hole on the opposite side.
Set the door cover aside.
NOTE:
Do NOT remove any of the eight screws on the
face of the cabinet (marked with below).
Doing so could result in damage to the dryer and
the need for a service call to repair the dryer.
Hole
p l u g
Twelve screws
Side
Interlock
button
screw
Long
screws
Short
Blank cover Door strike
Pull
Raise
Remove blank cover
Hole
plug
upper
hinge
hinge
cover
hinge
latch
mechanism
latch
hole
cover
hinge
bracket
hinge
cover
hinge
bracket
latch hole
cover
latch
mechanism
hinge
cabinet reversal complete
REVERSING THE TWO-WAY DOOR (continued)
INSTALLATION INSTRUCTIONSINSTALLATION INSTRUCTIONS