Installation guide

STEP6

Attaching the hot water ilne

NOTE: The 90 ° elbow fitting is not supplied with the

dishwasher and must be purchased separately (see

"Materials Needed" section).

STEP 1

To prevent leaks, wrap the dishwasher elbow with plumbing

tape firmly in a clockwise direction twice. Inspect the elbow

carefully for any breaks before you attach it to the water

supply line

STEP 2

To attach the elbow to the dishwasher, align the elbow

with the water supply opening of your dishwasher. To lock

the elbow in place, twist the elbow clockwise and tighten

until snug. When tightening the elbow, make sure that the

opening of the elbow ends up facing backwards. Use an

adjustable wrench to tighten. DO NOT overtightenJ

Attach hot water line to 90 ° elbow and route water line

underneath machine toward hot water connection.

Regardless of where the electrical supply cable originates,

position it 21" (54 cm) from the opening's left side. Extend

the cable 30" (77 cm) from the back wall.

Use tools recommended by the hot line manufacturer.