Installation guide

Note: Do not loosen or remove termlnal screws! Damage

may occur. Bend the wires so the exposed leads can reach

the appropriate contacts. Insert the black (hot) wire into

the left opening on the terminal strip marked %', the white

(neutral) wire in the middle opening of the terminal strip

marked "N', and the bare copper or green (ground) wire

into the right opening of the terminal strip marked "G'.

Make sure that the exposed (non-insulated) portion of each

stripped wire shows above and below the terminal screw.

Securely tighten the terminal screws, but do not over=tlghten

or damage may occur.