Installation guide

STEP 12

Restoring the junction box cover

Replace iunction box cover. Make sure the cover is seated

behind the front lip of the strain relief plate. Attach the

cover with the screw (part F) from the installation kit.

STEP 13

Adjusting the leg levelers

NOTE: if the dishwasher is nat leve!, it may nat

operate properly and could cause leaks.

Check that the leveling legs are firmly against the

floor.

• Place a level against the front panel.

• Check that the dishwasher is plumb, if

needed, adjust leg levelers until dishwasher is

plumb.

• Open the door.

• Place the level inside against the top of the

tub.

• Check that dishwasher is level from side to

side. Adjust the leg levelers as necessary

1. Level the dishwasher horizontally by turning

feet clockwise to raise or counter-clockwise to

lower front of unit.

2. Level vertically by turning center rear leg

leveler to raise or lower the back.

3. Puil the dishwasher out of the cabinet.

4. Insert rear leg leveler locking screw (part O).

(See #2 in the figure to the left)

5. Slide dishwasher back into the cabinet. Insert

front leg leveler locking screws (part G) as

shown to the left.