Installation guide

STEP6

Attaching the hot water llne

NOTE: The 90 ° elbow fitting is nat suppUied with

the dishwasher and must be purchased separately

(see _Materials Needed" section).

STEP 1

To prevent leaks, wrap the dishwasher elbow with plumbing

tape firmly in a clockwise direction twice. Inspect the elbow

carefully for any breaks before you attach it to the water

suppty tine

STEP 2

To attach the elbow to the dishwasher, align the elbow

with the water suppty opening of your dishwasher. To tack

the elbow in pMace, twist the elbow ctackwise and tighten

unfit snug. When tightening the etbow, make sure that the

opening of the etbaw ends up facing backwards. Use an

adiustable wrench to tighten. DO NOT avertighten!

Attach hat water line to 90 ° elbow and route water line

through channet as shown (staintess steer braided hose and

PEX instattatians anty - for copper cansutt a ptumber).

Regardless of where the electrical supply cable originates,

position it 21" (54 cm) from the apening's teft side. Extend

the cable 30" (77 cm) from the back wall.

Use tools recommended by the hat line manufacturer.