Installation guide

Place the assembMed strain relief plate back into the iuncfion
box and re-attach the screw. Make sure the tab on the right
side of the strain relief plate is outside the iuncfion box as
you slide it into place.
Note: Do not loosen or remove terminal screws! Damage
may occur. Bend the wires so the exposed leads can reach
the appropriate contacts, insert the black (hot) wire into
the left opening on the terminal strip marked "L', the white
(neutral) wire in the middle opening of the terminal strip
marked "N', and the bare copper or green (ground) wire
into the right opening of the terminal strip marked "G'.
©
14