Installation guide

IMPORTANT!
Before you begin, you must read the safety instructions!
PRE-INSTALL CHECKLIST
[] Unpack unit. Retain packing material until successful
installation is complete.
[] Remove all packing material from inside the dishwasher.
[] Inspect parts to ensure you have all the necessary
materials.
[] Flush household hot water supply for at least two
minutes.
[]Measure the enclosure area.
[] Is the opening at least 34" (87 cm) high and 235/8"
(60-61 cm) wide?
[] Is the opening near enough to the sink for the water line
and drain hoses to access plumbing?
[] Is the drain hose being connected to the garbage
disposal, if so, is the knockout plug on the disposal
removed?
[] Will the unit be installed close enough to the sink so that
drain hose length does not exceed 92" (234 cm) and so
that a portion of the drain hose is raised at least 20"
(51 cm) above the floor?
[] Do the openings for electric cable, water line and drain
hose routing through cabinet fit as shown in the manual?
[] Are the openings sanded smooth if wood or covered by
a protective gasket if metal?
[] Check that the incoming hot water supply line
is connected to the water inlet connection on the
dishwasher and has a water pressure of 15-I 45 PSI
(1 -1 0 bar). Wash program cycle times are based on
120F.
[] If installing in a corner, will the dishwasher door clear
cabinet hardware?
[] Determine mounting method based on dishwasher
model and countertop type.
Avoid Scalding or Electrical Shock Hazard!
Make sure the water supply and electrical supply are shut
off before installation or service.