Installation guide

3 Connect drain hose
Connect drain hose to waste tee or waste disposer
using one. of the following ‘options:
« Option A, Waste disposer —.no airgap
« Option B,-No waste disposer —no air gap
¢ Option C, Waste disposer—with airgap
° Option D, No waste disposer — with air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.
|. Fit rubber end of drain hose to
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
2. Attach rubber end of drain hose to
waste tee with a large drain hose
clamp (provided). Use pliers to
squeeze clamp open and move into
position. If the drain hose was cut,
use a 1%" to 2" (3.8 to 5 cm) screw-
type clamp (not provided).
Option C, Waste disposer — with air gap
Option A, Waste disposer — no air gap
—no air gap
Large drain. .
hoseclamp ~
Drain hose
te, ey . Drain trap
1. Using a hammer and screwdriver,
knock plug into disposer.
2. Use needle-nose pliers to remove
plug.
3. Attach drain hose to disposer inlet
with large drain hose clamp
(provided). Use pliers to squeeze
clamp open and move into position.
|} Large drain SS
) } hose clamp
Rubber hose
connector
Drain hose
Drain trap
Using a hammer and screwdriver,
knock plug into disposer.
Use needle-nose pliers to remove
plug.
Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
. Attach drain hose to air gap with
large drain hose clamp (provided).
Use pliers to squeeze clamp open
4 and move into position. If the drain
hose was cut, use a 1%" to 2" (3.8 to
5 cm) screw-type clamp (not
provided).
No waste disposer — no air gap
= —— Large drain
hose clamp
10
5. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from air gap
to disposer inlet.