Installation guide

Option D, No waste disposer — with air gap
No waste disposer - _ with air gap
ae
AWARNING
Se Stine clamps oe = Large drain mS
“< hose clamp =
Waste tee ty Rubber hose
os connector
Drain hose Tip Over Hazard
: Do not use dishwasher until completely installed.
Drain trap
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. Connect rubber end of drain hose
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
AWARNING
2. Attach drain hose to air gap with Excessive Weight Hazard
large drain hose clamp (provided).
Use pliers to squeeze clamp open Use two or more people to move and install
and move into position. If the drain dishwasher.
hose was cut, use a 172" to 2" (3.8 to Failure to do so can result in back or other injury.
5 cm) screw-type clamp (not
provided).
3. Use a rubber hose (not provided)
with screw-type clamps (not
provided) to connect from waste
tee to air gap.
Remove foam block
Foam block
Remove and discard the foam blocks located above the front
legs on each side of the dishwasher. The blocks cover the rope /
link pulleys on the dishwasher.
1