Installation guide

m Route water supply line and drain hoses into the cabinet.
HM Slide dishwasher partway into the cabinet opening. Allow for
access to the electrical terminal box.
VAL paben ne Cy counts a | bee cored Cbuode, hese cu:
Water Supply Line and Drain Moses
]. Connect water supply line to the water valve under the sink.
Connect ae
A. Hot water supply
2. Slide clamps onto drain hoses (Figure A). Do not cut drain hoses.
3. Push hose into drain connector until fully seated (Figure B). Several
“clicks” will be heard.
4. Slide clamp into position (figures C and D).
A B
D
5. Connect the drain hose using one of the following options:
Option 1: Waste Disposer, No Drain Air Gap
A. For new construction, remove disposer plug.
B. Connect drain connector to waste disposer.
C. Tighten clamp.
NOTE: This connection must be before the drain trap and at least 20"
(50.8 cm) above the floor where the dishwasher will be installed. It is
recommended that the drain hose be looped up and securely fastened to
the underside of the counter.
11