Installation guide

INSTALLATION REQUIREMENTS
OOS
Gather the required tools and parts before starting installation. Read and
follow the instructions provided with any tools listed here.
Tools Needed
m@ Pliers
Mm Phillips screwdriver
Mm Flat-blade screwdriver
m %e6" and 1/4" nut drivers or hex
sockets
M@ Measuring tape or ruler
142" hole saw bit
Parts Needed
10" adjustable wrench
Utility knife
Level
Cordless drill
Ve" drill bit
Security T-20 TORX® driver (on
some models)
A. 72" (182.9 cm} flexible water supply line
B. Zip tie
C. Appropriate sized UL Listed wire connectors (2)
T®TORX is a registered trademark of Acument Intellectual Properties, LLC
4
and Paris
Parts Supplied
Check that all parts are included.
A. 34" UL Listed/CSA Approved strain
relief
B. 1.25" hose clamp
C. Mounting bracket screws (8)
D. Unit mounting screws (4)
E. Drain hose connector
F Mounting brackets (4)
G. Drain connector spring clamps (2)
H. Trim strips (2)
1. Toe kick brackets (2)
J. Toe kick bracket screws (2)
K. Toe kick trim
L. Panel fasteners (on some models} (2)
M. TORX® screws (on some models) (10)
N. Drain hose