Installation guide

2. Remove two screws attaching access paneH and bwer
panei to dishwasher using a 1/4" hex socket, nut driver
or PhHHps screwdriven
3. Remove paneHs and set paneHs aside on a protective
surface.
4. Check that grounding chip is attached to the bwer
panel,
lower
panel
clip
5. AppiyTefion :" tape or pipe
joint compound to 90 °eibow
fitting and connect fitting to
water iniet vaive.
& Tighten elbow until snug, and
be sure that it faces to the
rear,
water inlet valve
7. Remove terminai box cover.
- if you are direct wiring: install a U.h-iisted/CSA°
certified champ connector to the terminai box. if using
conduit, use a U.L.°listed/CSA°certified conduit
connector.
- if you are installing a power supply cord kit, do so
now, following kit instructions,
terminal
box cover
dishwasher wires
- cable clamp
connector
HeJpfuJTip: Put cardboard under dishwasher until it is
installed in cabinet opening.The cardboard will help
protect floor covering during instaiiation,
8. Measure height of cabinet opening
from underside of countertop to
floor where dishwasher will be
instaiied (you need the iowest
point). Check chart for that height
opening. Put wheeis in the required
position.
wheel
Number of
Minimum Wheel
turns on
cutout height position front leg
34" (86.4 cm) 1 10
34-1/4" (87 cm) 2 5
34-I/2" (87.6 cm) 3 0
8.
Turn both front ieveier iegs to the same
height.
If the minimum cutout height is less than
34" (86.4 cm), the rear wheels can be
removed for additionai ciearance.This wiii
allow the dishwasher to fit into a 33-7/8"
(86 cm) high cutout, but the dishwasher
wiii be more difficult to move into
position, if the wheeis are removed,
protect the floor when moving the dishwashen
front leg
If you have built-up
floors
1. Measure height of opening
from underside of
countertop to buiit-up
floor, if the height is at
bast 33o3/4" (85.7 cm), the
dishwasher will fit into the
opening without
modification to the
countertop or flooring.
2. Put wheels in position 1
j countertop
rr
33-3/4"
(65,7 cm)
rain.
3.
and turn the front ieveier iegs up aii the vva%
Add shims as needed in the area shown to bring
dishwasher up to proper height.
NOTE: Shims must be secureiy attached to floor to
prevent their movement when the dishwasher is
operated.
2"
(5,1 cm)
shim shim
2-3/4" 6"
(7.0cm) (15.2cm) (ZOcm)
mnstaH ¢ustorn door panel kit ion some models)
If instaiiing a custom door panei kit, instaii it now foiiowing
instructions included with kit,
10