Installation guide

Electrical Shock Hazard
Electricaly ground dishwasher.
Connect ground wire to green ground connector
in terminal box.
Do not use an extension cord.
Falure to follow these instructions can resut in
death, fire, or electrical shock.
4. Form bare ground wire into a U-shaped hook. Wrap ground
wire hook clockwise around ground connector and under the
washer.
5. Securely tighten ground connector.
__ __ ! Ground wire Washer
Ground
GLdw,.
6. Tighten clamp connector or conduit Screws
co_c.screws.
Reinstall terminal box cover with
wires inside terminal box.
The cover must be outside the box on
the left side.
8. Make sure no wires are pinched by ......... ._......
cover.
9. Do not plug the dishwasher cord into the outlet until instructed
to do so.
10. Check that power supply cord does not touch dishwasher motor
or lower part of dishwasher tub.
1. Tighten 90 ° elbow fitting to valve.
2. Check for leaks.
2.
3.
4.
5.
6.
H
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat previous step.
To help minimize vibration,
route drain hose to avoid
contact with motor, door
springs, water line, cabinet,
flooring or the edge of the
hole where it passes
through the cabinet.
Do not remove drain loop
from side of dishwasher.
Place pan under end of
drain hose. Pan will collect
any water in drain hose.
, o7//
Place the smaller drain hose clamp onto the small end of the
drain hose.
Hose clamp
/
Push the drain hose into the connector up to the stop on the
drain hose.
Connector Stop
Use pliers to open clamp and slide clamp onto connector
between stops on connector as shown.
Hose clamp
/
Stops
Be sure rubber washer is properly seated in fitting. Slide the 3/4"
fitting up to the valve and hand tighten to avoid unintentional
cross-threading. Hand tighten until the coupling is tight. Using
pliers, check the tightness of the coupling. An additional 1/4 to
1/2turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
14