Installation guide

Option2, Powersupplycordmethod:
NOTE:Amating,threeprong,ground-typewanreceptacb
isrequiredinacabinetnextto thedishwasheropening.
1. DrHHa 1ol/2"
(3.8cm)hobin optionalpreferred
thecabinetrear locationslocations
orside,Preferred[ii_i
andoptional ......
bcafionsare
shown.
2. VVoodcabinet:
Sandhobuntil
smootL
Metai cabinet: Cover hone with grommet (Part No.
302797) inciuded with power suppiy cord kit.
mnstall the water line
NeJpfuJTip: Routing the water Hne through the Heftside
of cabinet opening will make water connection easier.
Drill a minimum 1/2" {1.3 cm) hole in the cabinet side,
rear or floor. Preferred and optional locations are
shown.
preferred
locations
optional
locations
2. Measure overall length
of copper tubing
required.
3. Attach copper tubing
to the water line with a
manual shutoff valve.
copper
tubing
4. Slowly feed copper
tubing through hole in
cabinet. Copper tubing will bend and kink easily, so be
gentle.The copper tubing should be far enough into the
cabinet opening to connect it to dishwasher inlet on the
front left of the dishwasher.
5. Turn water shutoff valve to "ON" position. Flush water
into a shallow pan to get rid of particles that may clog
the inlet valve.
6. Turn shutoff valve to "OFF" position.
mnstaH the drain hose
IMPORTANT: Always use a new drain hose.
1, Drill a 1-1/2" (3,8 cm)
diameter hole in
cabinet wall or floor on
the side of the opening
closest to the sink
2. Connect drain hose to waste tee or waste disposer
using one of the following methods:
o Option 1, Waste disposer-with air gap
o Option 2, No waste disposer- with air gap
o Option 3, Waste disposer - no air gap .×
Option 4, No waste disposer - no air gap _
_an air gap is recommended
HeJpfu_Tip:To reduce the vibration of the hose, keep
the hose away from the floor and the edge of the hole
where it passes through the cabinet.
Option 1, Waste disposer = with air gap:
1. Remove the disposer knockout plug. Cut end of drain
hose if needed (do not cut ribbed section}.
2. Attach drain hose to air gap with large spring-type
clamp. If the drain hose was cut, use a 1-1/2" to 2"
(3.8 to 5 cm) screw-type clamp x.
3. Use a rubber hose connector _ with spring or screw-
type chmps x to connect air gap to disposer inlet.
This connection must be before the drain trap and at
least 20" (50.8 cm) above the floor where dishwasher
will be installed.
drain hose -
cut here if needed
rubber hose
connector
gap
spring-type
clamp
"" drain
hose
drain trap
E
4. Insert drain hose | drain hose
through hole cut in
cabinet to the front
center of opening where
drain connection will be / ...................
made.
Parts available from local plumbing supply stores