Installation guide

Check Operation
Referto theUseandCareGuidepackagedwiththe
cooktopfor operatinginstructionsandfor careand
cleaningof yourcooktop.
Donottouchtheburnersuntilyouarecertainthatthe
cooktophascompletelycooled.Theymaybehot
enoughto causeburns.
IA, InstallBurnerCaps=RegularBurners
Thiscooktopisequippedwithsealedburnersasshown
(seeFigure8).
A. Unpackyourburnerheadsandburnercaps.
B. Placeburnerheadovereachgasorifice,matching
theheadwiththeorificesize.Becarefulnot to
damagethe electrodewhile placingthe head
overthe orifice. Makesureelectrodefitscorrectly
intoslotinburnerhead.
C. Placea burnercaponeachburnerhead,matching
thecapsizetotheheadsize.Eachburnercaphasan
innerlocatingringwhichcentersthecapcorrectlyon
theburnerhead.
D. Besurethatalltheburnercapsandburnerheadsare
correctlyplacedBEFOREusingyourcooktop.
IA, InstallBurnerCaps- Dual Burners
Some models are equipped with dual sealed burners as
shown (see Figure 9). Make sure that the Burner Head,
Burner Caps and Burner Skirt are installed properly and
at the correct locations.
1. Remove all packing tape from cooktop and the dual
burner.
2. Discard all packing material located under all Burners (if
applicable).
3. To install Burner Head, Caps & Skirt, refer to figure 1
and follow the following steps:
Step 1:Align Burner Head PinA on Burner Base Hole.
Step 2: Place Burner Skirt around Head and Base.
Step3: Align BurnerOuter Cap Hole into Burner HeadPinB.
Step 4: Place Burner Inner Cap centered on Burner
Base.
5. Put back the grates on the cooktop.
Burner ---_---_
Inner Cap _S
Step 4
Locating Ring
Burner Cap__ _
J
Burner Head
Gas Opening
Burner
Electrode
Cap Hole Step 3
Burner
Skirt
\\\
Head '__
Burner Burner
Head
Pin B _ _ PinA
%
Burner Head _ --- Step 2
Burner
Base
Hole
Burner
Figure 8
NOTE: There are no burner adjustments necessary on
this cooktop.
Step 1
Figure 9
2. Turn on Electrical Power and Open Main
Shutoff Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
cooktop and supply line connectors have been carefully
checked for leaks and the cooktop has been connected
to electric power.
To operate the surface burner:
A. Push in and turn a surface burner knob to the LITE
position. You will hear a small ticking noise; this is the
sound of the electric ignitor which lights the burner.
B. After the burner lights, turn to the desired flame size.
The controls do not have to be set at a particular
mark. Use the marks as a guide and adjust the flame
as needed.