Installation guide

ManualsBrandsKenmore Elite ManualsCooktopOfficial Kenmore Elite electric cooktop

_NSTALLAT_ON AND SERVICE MUST BE PERFORMED BY A QUAUNED _NSTALLER.

_MPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE _NSTRUCT_ONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasotine or other flammabte vapors and tiquids in

the vicinity of this or any other appliance.

IMPORTANT INSTALLATION INFORMATION

All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC only

ele(trkal supply with ground.

Minimum distance between cooktop and overhead cabinetry is 30" (76.2 (m).

Cooktop Dimensions

(76.2 cm)

* 30" (76.2 cm) rain. for

unprotected cabinet and

24" (6! cm) rain. for cabinet

with protected bottom surface.

** Do not obstruct these areas.

Cooktop Cutout Dimensions

Air exhaust**

Fresh air intake**

4" X 8" (I 0.2 cmx 20.3 cm)

opening to route armored cable.

All dimensions are stated in inches and (cm).

Allow 2" (5 cm) space below the armored cable opening to clear the electric cable and

allow space for installation of tile junction box on the wall at the back of the cooktop.

Printed in United States

P/N 318201425 (0509) Rev.A

English - pages I-6

Espafiol - pages 7_12

Summary of content (12 pages)

PAGE 1
_NSTALLAT_ON AND SERVICE MUST BE PERFORMED BY A QUAUNED _NSTALLER. _MPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE _NSTRUCT_ONS FOR FUTURE REFERENCE. the vicinity FOR YOUR SAFETY: Do not store or use gasotine or other flammabte of this or any other appliance. vapors and tiquids in IMPORTANT INSTALLATION INFORMATION All electric cooktops run off a single phase, three-wire or four-wire cable, 240/208 volt, 60 hertz, AC only ele(trkal supply with ground.
PAGE 2
Overhead Cabinet Should Not Exceed a Maximum Depth of 13" (33 cm) 4 30" (76.
PAGE 3
Important Notes to the Installer 1. Readallinstructions contained intheseinstallation instructions beforeinstalling thecooktop. 2. Remove allpackingmaterialbeforeconnecting the electrical supplytothecooktop. 3. Observe allgoverning codes andordinances. 4. Besureto leavetheseinstructions withtheconsumer. Important Note to the Consumer Keeptheseinstructions withyourUseandCare Guide for future reference. IMPORTANT INSTRU SAFETY S 4.
PAGE 4
DO NOT ground to a gas suppty pipe, DO NOT connect to electrica! power suppJy until appliance is permanently grounded, Connect the ground wire before turning on the power. Where local codes permit connecting the appJiancegrounding conductor to the neutral (white) wire (see figure 3): 1. Disconnect the power supply. 2. In the circuit breaker, fuse box or junction box, connect appliance and power supply cable wires as shown in figure 3.
PAGE 5
Cooktop Installation 1. Visuallyinspectthe cooktopfor damage.Alsomake sureallcooktopscrewsaretight (seeFigure5). 3. Set the cooktop into the countertop cutout. NOTE: Do not use caulking compound; cooktop should be removable for service when needed. Do not remove the nylon spacers on the edges of the cooktop. These spacers center the cooktop in the space provided. The cooktop must be centered to prevent excess heat buildup that may result in heat damage or fire (see Figure 7).
PAGE 6
Notes
PAGE 7
LA mNSTALACmON Y EL SERVmCmODEBEN SER EFECTUADOS POR UN mNSTALADOR CALmFmCADO. mMPORTANTE: GUARDE ESTAS mNSTRUCCmONESPARA USO DEL mNSPECTOR LOCAL DE ELECTRmCmDAD. LEA Y GUARDE ESTAS mNSTRUCCmONESPARA REFERENCmA FUTURA.
PAGE 8
Elarrnario superior nodebesobrepasar una profundidad maxirna de13"(33cm) 30"(762crn)rnin_ deespacio entrelapartesuperior delfog6n ylaparteinferior deunarrnario dernadera o metalsinproteccion ompartimiento de "_'_ combustible m4_scercano / ! 0" sobre la parte superior de _(254 arrnano crn) G-24"(61crn)rnin_ cuando la parteinferiordelarrnario de rnadera o metalest,1 protegida porunaplatacortafuego retardante dellamadeno rnenos de1/4".cubierta con unaI_imina deacerornsgno inferioralNo 28.
PAGE 9
Notas importantes 1. 2. 3. 4. para eminstamador Lea todas las instrucciones contenidas en este manual antes de instalar la estufa. Saque todo el material usado en el embalaje de la estufa antes de conectar el suministro electrico a la estufa. Observe todos los codigos y reglamentos pertinentes. Deje estas instrucciones con el consumidor. Nota importante amconsumidor Conserve estas instrucciones y el Manual del usuario para referencia futura.
PAGE 10
Conexi6n El6ctrica No podr& Conecte el (:able blindado flexible que se extiende desde la superficie del artefacto hasta la (aja de empalmes utilizando una grapa de alivio de tensi6n adecuada en el punto en que el (:able blindado entra en la caja de empalmes. Realizar luego la conexi6n el6ctrica de la siguiente manera. En este e[ectrodomestico puesta a tierra. Este electrodorn_stico viene equipado con un cable de conexi6n de cobre.
PAGE 11
NOTA AL ELECTRtCtSTA: Los conductores de cable 3.Fije la estufa en el recortado del armario. blindados provistos con este artefacto son aprobados pot UL para la conexion al alambrado de casa de un calibre mayor. El aislamiento de los conductores esta calificado para temperaturas mas altas que las del alambrado de lacasa. Lacapacidaddecorrientedelconductoresta gobernada por la (alificaci6n de la temperatura del aislamiento alrededor del alambre en vez de solamente el calibre del alambre.
PAGE 12
Notas 12