Installation guide

ManualsBrandsKenmore Elite ManualsCooktopOfficial Kenmore Elite electric cooktop

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the

vicinity of this or any other appliance.

Cooktop Dimensions

30" Min. *

Air Exhaust(76"2 cm)

IMPORTANT INSTALLATIONINFORMATION

• All electric cooktops run off a single phase, three-wire or four-

wire cable, 240/208 volt, 60 hertz, AC only electrical supply

with ground.

• Please note minimum distance between cooktop and adjacent

and overhead unprotected cabinetry is 30" (76.2 cm).

* 30" (76.2 cm) min. for unprotected cabinet

24" (61 cm) min. for protected surface

_The corners of this unit are

fragile. Carefully install the cooktop by its

sides. When installing, never let the weight

of the unit rest on any one corner.

Cooktop Cutout Dimensions

Fresh Air Intake

-------- 4" X 8" (10.2 cm x 20.3 cm)

opening at the right rear

to route armored cable

if a panel is present

Figure 1 - 30" Model shown only

MODEL A. WIDTH B.DEPTH C.HEIGHT D BOXWIDTH E BOXDEPTH

30" CeramicModel 303A(78.1) 211/2(54.6) 2V4(5.1) 29 (73.7) 193/8(49.2)

36" CeramicModel 363A(93.3) 21Y2(54.6) 2Y4(5.1) 35(88.9) 193/8(49.2)

MODEL MINIMUM MAXIMUM MINIMUM MAXIMUM COOKTOF

30" CeramicModel 29%(75.2) 30 (76.2) 201/4(51.4) 20V2(52.1) 6 (15.2)

36" CeramicModel 35%(90.5) 36 (91.4) 201/4(51.4) 20V2(52.1) 6 (15.2)

All dimensions are in inches (cm).

* Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for

installation of the junction box on the wall at the back of the cooktop.

Printed in United States

P/N 318201435 (0706) Rev.

English - pages 1-6

Espa¢_ol- pages 7-12

Summary of content (12 pages)

PAGE 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND vicinity SAVE THESE INSTRUCTIONS FOR FUTURE FOR YOUR SAFETY: Do not store or use gasoline or other flammable of this or any other appliance. Cooktop Dimensions REFERENCE. vapors and liquids in the IMPORTANT INSTALLATION INFORMATION • All electric cooktops run off a single phase, three-wire or fourwire cable, 240/208 volt, 60 hertz, AC only electrical supply with ground.
PAGE 2
Overhead Cabinet Should Not Exceed a Maximum Depth of 13" (33 cm) A 2" (5.1 cm)Min. Recommended Distance Between Rear Edge of Cutout and Nearest 10" Combustible Surface ( 25.4 cm) Above Countertop 30" (76.2 cm) Min. Clearance Between the Top of the Cooking Platform and the Bottom of an Unprotected Wood or Metal Cabinet _i 31 Min. J 18" (45.7 cm) 24" (61 cm)Mi_ Bottom of Wood or Metal Cabinet is Protected by Not Less Than 1/8" Flame Retardant Millboard Covered With Not Less Than No.
PAGE 3
Important 1. 2. 3. 4. Notes to the Installer Read all instructions contained in these installation instructions before installing the cooktop. Remove all packing material before connecting the electrical supply to the cooktop. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference.
PAGE 4
Electrical Connection Connect the flexible armored cable that extends from the surface unit to the junction box using a suitable strain relief at the point the armored cable enters the junction box. Then make the electrical connection as follows. Electrical ground is required on this appliance. This appliance is equipped with a copper conductor flexible cable.
PAGE 5
If cooktop is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes DO NOT permit grounding through the neutral (white) wire: If your cooktop has a 3-wire cable (see figure 6): 1. Disconnect the power supply. 2. Separate the green (or bare copper) and white appliance cable wires. 3. Cap the white wire from the power supply cable if a 3-wire appliance cable is supplied. 4.
PAGE 6
Cooktop Installation 1. Visually inspect the cooktop for damage. Also make sure all cooktop screws are tight (see Figure 8). 7 9/16" 2 Nylon / /. 2 Retainer brackets Screws Figure 8 2. Install the retainer brackets (See Figure 9). _ ........ _, ......... Figure 10 The corners of this unit are fragile. Carefully install the cooktop by its sides. When installing, never let the weight of the unit rest on any one corner.
PAGE 7
LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. PARA SU SEGURIDAD: No almanece ni utilice gasolina u otros vapores y liquidos inflamables en la proximidad de este o de cualquier otto artefacto.
PAGE 8
Elarmario superior nodebesobrepasar una profundidad maxima de13"(33cm) ' 30"(76.2cm)rain. deespacio entrela partesuperior del fog6nylaparte inferiordeunarmario demadera o metal sinprotecci6n. 2" (5.1 cm) rain. distancia recomendada entre el horde trasero del corte y el compartimiento de combustible m_is cercano sobre la parte superior del armario c. 10" cm) 18" (45.7cm) 24"(61cm)rain.
PAGE 9
Notas importantes 1. 2. 3. 4. para el instalador Lea todas las instrucciones contenidas en este manual antes de instalar la estufa. Saque todo el material usado en el embalaje de la estufa antes de conectar el suministro electrico a la estufa. Observe todos los c6digos y reglamentos pertinentes. Deje estas instrucciones con el consumidor. Nota importante al consumidor Conserve estas instrucciones y el Manual del usuario para referencia futura.
PAGE 10
Instrucciones NO conecte el alambre de desembalaje puesto a tierra a una tuberia de suministro de gas. NO conecte el suministro de energia el&ctrica hasta que el electrodomestico haya sido permanentemente puesto a tierra. Antes de encender la alimentaci6n el&ctrica; conect& de manera permanente el cable de tierra, despu&s complete todas las conexiones restantes. Asegure la tapa protectora de la caja de ensambladura. Plata con los numeros de modelo (debajo de la cubierta) Figura . 2.
PAGE 11
Si su cocina tiene un cable de 4 hilos que debe conectarse a una caja de juntas con conexi6n a tierra de 3 hilos (vet figura S): 1. Desconecte el suministro electrico. 2. Cable desde el suministro Alambre desnudo Alambre rojos En el interruptor automatico, caja de fusibles o caja de juntas: conectar el aparato y los cables residenciales como se muestra en la figura 5. Cable desde el suministro de energia -Alambre blanco Alambre negros de energia Alambre blanco (neutral) de empalmes \ Alambre --.
PAGE 12
Instalacion de la estufa 1.Visualmente inspecciones la estufa para daflos. Verifique ademas que todos los tornillos de la estufa est_n bien ajustados (Figura 8). 7 9/16" 2 esF de nil6n ...... 2 Mensulas de sostenimiento _-_ ,-" ................... Figura 10 Las esquinas de esta unidad son fragiles. Cuidadosamente instale la estufa sujetandola pot los lados. AI instalarla, nunca deje que el peso del aparato se recargue sobre una sola esquina. Tornillos Figura 8 2. Instale las m_nsulas de sost_n.