KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. U.S.A. PIVYEGINING] FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS Overhead Cabinet Should Maximum Depth of 13" (33 em) Not Exceed a 30" (76.2 cm) Min. Clearance Between the Top of the Cooking Platform and the Bottom of an Unprotected Wood or Metal Cabinet \ 24" (61 cm) Min. when Bottom of Wood or Metal Cabinet is Protected by Not Less Than 1/8" (0.3 cm) Flame Retardant Millboard Covered With Not Less KK Min. Recommended Distance Between Rear Edge of Cutout and Nearest Combustible Surface 10" ( 25.
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS Important Notes to the Installer |. OK w 2. Read all instructions contained in these installation instructions before installing the cooktop. Remove ali packing material before connecting the electrical supply to the cooktop. Observe all governing codes and ordinances. Be sure to leave these instructions with the consumer. Only certain cooktop models may be installed over certain built-in electric oven models.
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS lf the cable from appliance is equipped with 3 wires: Where local codes permit connecting the appliancegrounding conductor to the neutral (white) wire (see figure 3): |. Disconnect the power supply. 2. In the circuit breaker, fuse box or junction box, connect appliance and power supply cable wires as shown in figure 3.
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS lf the cable from appliance is equipped with 4 wires: Where local codes permit connecting the appliancegrounding conductor (wire) to the neutral (white) wire (see figure 5): |. Disconnect the power supply. 2. In the circuit breaker, fuse box or junction box, connect appliance and power supply cable wires as shown in figure 5.
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS Cooktop Installation 1. Visually inspect the cooktop for damage. Also make sure all cooktop screws are tight (see Figure 5). Hole located under the burner box to fix the retainer bracket. Position on Screws Figure 5 2. Install the retainer brackets. See Figure 6. The retainer brackets MUST be installed, to meet local codes or, in their absence, with the National Electrical Code ANSI/NFPA No. 70—latest edition (see Figure 6).
KENMORE INDUCTION COOKTOP INSTALLATION INSTRUCTIONS For typical under counter installation of an electric built-in oven see Figure below. Only certain cooktop models may be installed over certain built-in electric oven models. Approved cooktops and built-in ovens are listed by the MFG ID number and product code (see the insert sheet included in the literature package and cooktop installation instructions for dimensions). Note 1: 4” x 4” (10.2 X 10.
KENMORE Notes INDUCTION COOKTOP INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR UN INSTALADOR [—tnados Unidos CALIFICADO. IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. AVADVERTENCIA PARA SU SEGURIDAD: No almanece ni utilice gasolina u otros vapores y liquidos inflamables en la proximidad de este o de cualquier otro artefacto.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION El armario superior no debe sobrepasar una profundidad maxima de 13” (33 cm) 30" (76.2 cm) min. de espacio entre la parte superior de cubierta y la parte inferior de un armario de madera o metal sin proteccién. \ k min. distancia recomendada entre el borde trasero del corte y el compartimiento de combustible mds cercano sobre la parte superior del armario Falk 24" (61 em) min.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Notas importantes para el instalador ]. 2. os 3. NOTA: El tamanio de los cables y de las conexiones debe de estar en conformidad con el tamano del fusible y con la capacidad del electrodoméstico y de acuerdo con el Cédigo Eléctrico Nacional ANSI/NFPA No. 70 - ultima edicién y los cédigos y reglamentos locales. Lea todas las instrucciones contenidas en este manual antes de instalar la estufa.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Este electrodoméstico se fabrica con un alambre de puesta a tierra verde (o de cobre sin forro} conectado con el marco. PGi] NO conecte el alambre puesto a tierra a una tuberia de suministro de gas. NO conecte el suministro de energia eléctrica hasta que el electrodoméstico haya sido permanentemente puesto a tierra. Conecte el alambre de puesto a tierra antes de enchufar por primera vez el electrodoméstico.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Si el cable de la unidad es equipada con 4 alambres: Donde los cédigos locales permitan conectar el conductor de puesta a tierra del eléctrodoméstico al neviral (blanco) (ver figura 5): ]. Desconecte el suministro eléctrico. 2. Enel interruptor automdtico, caja de fusibles o caja ce juntas: conectar el aparato y los cables residenciales como se muestra en la figura 5.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Instalacion de la estufa Agujero localizade |. Visualmente inspeccione la estufa para dafios. Verifique ademds que todos los tornillos de la estufa debajo de la caja de quemador para estén bien ajustados (Figura Espaciadores (8) fijar el soporte 7). deteniendo. Ménsulas de sostén (2) Coloque los soportes en la unidad como se muestra. Figura 9 Tornillos Revision de operacién i 7 Figura 2.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Instalacién tipica para una estufa eléctrica encima de un horno de pared instalado debajo del mostrador Sélo ciertos modelos de tapas de cocina se den instal bre ciert delos de h PUCGEN INSEAIAT SODEE CISTHOS MOAGIOS GE MOMs eléctricos empotrados.
INSTRUCCIONES DE INSTALACION PARA LA CUBIERTA DE INDUCCION Notas 16