Installation guide

ManualsBrandsKenmore Elite Manualswall ovenOfficial Kenmore Elite wall oven

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

Your new wa[[ oven has been designed to fit a Jimited variety of cutout sizes to make the job of installing

easier. The first step of your installation should be to measure your current cutout dimensions and

compare them to the cutout dimensions chart below for your model, You may find little or no cabinet

work being necessary,

Do not remove spacers (if equipped) on the side walls and/or on the back of the bui[t4n

oven, These spacers center the oven in the space provided. The oven must be centered to prevent

excess heat buildup that may result in heat damage or fire,

NOTES:

1, Base must be capable of supporting 150 pounds (68 kg) for 27" models

and 200 pounds (90 kg) for 30" models.

2, Allow at least 21" (53.3 cm) clearance in front of oven for door 1"(25cm) _]_

depth when it is open. " Min _- _-

3. Dimension G (cutout depth) is critical to ] " I

the proper installation of the built-in . _----<. _ < _ .

oven. If the oven decorative trim does C.. j '"_'[ _ _ /G-"_.- :: Hole.,

. E , - E. . ,r , i _ _ o o-_ ' TOF LaDle

no]: Dutt against the caD[he%or [Tnoise H J ""-F .... i /

is heard on convection models, verify ,,

dimension G to assure it is the required 27_'I;_i, [ ._,_

depth _ < _ '" "'" '7 6 cm_

i /_ - "">-8 k , f

4, For a cutout height greater than .. ", ] _ <_ '. €z-:s;--_ I

27 L0 (70.6 cm) add one 2 ...... _ _ o.< j ..... _. _ _

.--.......... _ _/_ / m} < _,,

(B cm) w,de wood shim of _---- _ _ _ , _<- _ t

" uoor upen _ K J,I Spacer I l r_ _ \ /

appropriate height to each side 'see note 2.... J D/ I / _ _ t"_A, ,

. - t ) ....... _ " i_ 1¼"

of the opemng under the ....._ <"-_l'_ _-__ .... _ \

appliance side rails. A. "_ Min. /'J

_ "_ Electrical

* Suggested distance from floor is3!" (78.7 cm). 2" (5 cm) WideWood v Junction Box

Minimum required distance is 4 Y2" (I 1.4 cm) Spacer if Needed

.... Figure 1

27 and 30 Single Walt Ovens (Double ovens see Figure 2)

PRODUCT D[MENS!ONS

27" (686 cm)Wall Oven 27 (686)

30" (762 cm) Wall Oven 30 (76.2)

2971_ (738)

24% (625) 241h (622)

28¼ (71.8) 241h (622)

27" (686 cm) Wall Oven 2478 (63.2)

30" (762 cm) Wall Oven 281/_(724)

All dimensions are in inches (cm)

Printed in United States

25¼ (64.1)

29 (737)

271/4(69.2)

27¼ (69.2)

281/_(72.4) 2778 (689) Min

281/_(724) 301A (765) Min

P/N 318201512 (0412) Rev D

English - pages 1-10

Espai]ol - p_ginas 11-20

Summary of content (20 pages)

PAGE 1
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. the vicinity FOR YOUR SAFETY: Do not store or use gasoline or other flammable of this or any other appliance. vapors and liquids in Your new wa[[ oven has been designed to fit a Jimited variety of cutout sizes to make the job of installing easier.
PAGE 2
Do not oven, These spacers excess heat buildup remove spacers (if equipped) on the side center the oven in the space provided, that may result in heat damage or fire, wails and/or The oven must on the back of the bui[tdn be centered to prevent I 1" (2.5cm) Min. B 3" (7.6 cm) Max. Door Open (seenote 2) Junction 2" (5 cm) Wide Spacer if Needed Box NOTES: 1. Base must be capable of supporting 300 pounds 4.
PAGE 3
Important Notes to the [nstammer 1. Read all instructions contained in these installation instructions before installing the wall oven. 2. Remove all packing material from the oven compartments before connecting the electrical supply to the wall oven. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Oven door may be removed to facilitate installation. 6. THESE OVENS ARE NOT APPROVED FOR STACKABLE OR SIDE-BY-SIDE INSTALLATION.
PAGE 4
Electrical Shock Hazard • E[ectrka[ ground [s required on this app!iance. • Do not connect to the electrical supply until appliance is permanently grounded, • Disconnect power to the junction box before making the eJectrkaJ connection, • This appliance must be connected to a grounded, metallic, permanent wiring system, or a grounding connector should be connected to the grounding terminal or wire lead on the appliance. • Do not use a gas supply line for grounding the appliance.
PAGE 5
if oven is used in a new branch circuit installation (!995 NEC), mobile home, recreational vehicle, or where toca[ codes DO NOT permit grounding through the neutra[ (white) wire (see figure 4): 1. Disconnect the power supply. 2. Separate the green (or bare copper) and white appliance (:able wires. 3. In the circuit breaker, fuse box or junction box: connect appliance and power supply cable wires as shown in Figure 4. Cable from Power Supply Ground Wire Wire 5.
PAGE 6
IMPORTANT Do not lift the oven by the door handle. 3. Insert the oven into the cabinet opening. Slide oven inward leaving IY2" (3,8 cm) clearance between the oven and front of cabinet (see Figure 6), Pull tile armored cable through the hole for it in tile cabinet and toward the junction box while moving the appliance inward. Mounting bracket released Oven removed from the cabinet Hole where to insert the tool J Figure 7 lye" (3.8 cm) clealance between unit Figure 6 4.
PAGE 7
6.Fortypicalundercounterinstallation ofanelectric builtdnovenseeFigure below. Onlycertaincooktopmodelsmaybeinstalled overcertainbuiltdnelectric ovenmodels. Approved cooktops andbuiltdnovensarelistedbytheMFGIDnumberand productcode(seetheinsertsheetincludedintheliteraturepackage andcooktopinstallation instructions forthe dimensions). Cabinet side filler panels are necessary to isolate the unit from adjoining cabinets.
PAGE 8
__ 4---- 18"(4E7cm)Max, "r1 , 5" Max. Flare (12,7 cm) _ Flexible Appliance Conduit Union I_ 4"(10 cm) LJ (16 RightSide ___3__ ! I I Wall Oven Cabinet /'T_7]1 1 __ Cabinet sides or filler panel 6 1/2" Min, _] Flare Union _ k2.
PAGE 9
6. Leveling 1. the Wail Oven 2. Install an oven rack in the center of the upper oven (see Figure 11). Place a level on the ra(k. Take 2 readings with the level placed diagonally in one direction and then the other. Use wood shims under the wall oven to level 3. if necessary. Repeat in the lower oven if you have a double cavity wall oven. If the level indicates that tile ra(k is not level, use wood shims to reach a compromise for both ovens. 7.
PAGE 10
Notes 10
PAGE 11
LA mNSTALACmON Y ELSERVmCmO DEBENSEREFECTUADOS PORUN mNSTALADOR CAUFmCADO. mMPORTANTE: GUARDEESTASmNSTRUCOONES PARAUSODELmNSPECTOR LOCALDE ELECTRmCmDAD. LEAY GUARDEESTASmNSTRUCOONES PARAREFERENOA FUTURA. PARA SU SEGURIDAD: en la pro×imidad No almanece de este o de cualquier otto ni utilke El primer paso para su instaladbn debe de set el de medir que se indkan en el cuadro de dirnensiones del hueco trabajo de carpinteria ser_ necesario.
PAGE 12
No quite los separadores de los muros [atera[es o/y de [a parte posterior de[ homo empotrado. Estos espadadores centran el homo en el espado prov[sto. El homo debe estar centrado preven[r una concentrad6n exces[va de ca[or que podr_a resu[tar en daffos pot el ca[or o un [ncend[o. para B Puerta Abierta 3" (7.6 cm) Max " (yea la nora 2) Caja el6trica Espaciador de Madera de 2" (5 cm) de ancho, si es necesario ..... _"A NOTES: la dimensi6n G esta en conformidad 1.
PAGE 13
Notas importantes para e[ insta[ador Lea todas las instrucciones antes de instatar el homo, 2. Saque todo el material usado en e! embalaje del compartimiento del homo antes de conectar el suministro electrico o de gas a la estufa. Observe todos los cOdigos y reglamentos pertinentes. Deje estas instrucciones con el consumidor. La puerta del homo se puede retirar para facilitar la instalacion. ESTE HORNO NO ESTA APROBADO PARA LA INSTALACION APILABLE O DE LADO A LADO. 3. 4. 5. 6.
PAGE 14
Riesgo de choque Donde tos c6digos locales permitan conectar el conductor de puesta a tierra del el&ctrodorn&stico al neutral (blanco} (yea figura 3): (Un cordon flexible o cable de 3 conductores debe de set reemplazado con un cordon flexible o (:able de 4 conductores donde la conexi6n del conductor a tierra al neutro esta el_ctrico o Una puesta a tierra se require en este aparato. o No Io conecte a la corriente eiectrica hasta que el aparato haya sido puesto a tierra.
PAGE 15
Si el horno se usa en una instalaci6n de circuito de ramal nuevo (1996 NEC), en una casa rodante, en un vehiculo para recreaci6n o si los c6digos locales NO permiten la conexi6n a tierra a trav6s del cable neutral (blanco) (ver figura 4): 1. Desconecte el suministro electrico 2. Separe el alambre verde (o (obre desnudo) y el alambre blanco del electrodom6stico. En el interruptor automatico, caja de fusibles o caia de juntas:conectar el aparato y los cables residenciales 3. 5.
PAGE 16
JMPORTANTE No Jevante eJ homo pot Ja maniia de Ja puerta. Bracket_ 3.1nsertar el homo en la abertura del gabinete. Deslizar el horno hacia dentro deiando IY2" (3,8 cm) de espacio libre entre el horno y la parte delantera del gabinete (ver la Figura 6). Empujar el cable blindado a trav6s del orificio del gabinete y hacia la caia de paso mientras se desliza el accesorio hacia adentro.
PAGE 17
6. Para una instalaci6n tipica de un homo el6ctrico incorporado debajo del mostrador, $6!o ciertos modelos de tapas de cocina se pueden instalar sobre ciertos mode!os de hornos electricos empotrados. Las tapas de cocina y los hornos empotrados se mencionan por su nOmero de identificaci6n MFG ID y c6digo de producto (ver la planilla que se inciuye en e! paquete de literatura y las instrucciones de instalaci6n de la cocina donde est_in detalladas las dimensiones).
PAGE 18
_L_ _ 18"(45.7 cm) Max.
PAGE 19
6. Asegurese pared 1. 2. 3. esta de que el horno 7. Verificaci6n de del funcionamiento Su modelo esta equipado con un Control Electr6nico de Homo. Cada una de las funciones ha sido controlada en fabrica antes del despacho. Sin embargo, le sugerimos verificar el funcionamiento de los controles electr6nicos una vez mas. Consulte la Guia de Uso y Cuidado para ver el funcionamiento del horno. a nivel Instale una rejilla al centro del horno superior (yea la Figura I 0).
PAGE 20
Notas 20