Installation guide

if oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system. (see Figure 3):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
Connect appliance and power supply cable wires as
shown in Figure 3.
Cable from Power Supply
Ground Wire _ _- _'_x._
Red _::,, ::[_ hite Wire
i Ji __w ,
Black
Ground Wire '_'_-_ _:_ _'<_b'_-_ Wire
(Bare or Green _
Wire) J _,_.l ".........
Junction Box _ii_ _-'_ U.Li;'L;'_ted ire
Conduit Connector
Cable from appliance (or CSA listed)
Figure 3
4=WIRE GROUNDED JUNCTION BOX
Model and Serial Number Location
The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
4. Cabinet Installation
Do not lift the oven by the door handle.
Heavy Weight Hazard
, Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in injury
or damage to the unit.
O Unpack the wall oven. Remove the bottom and
middle trim taped on the oven side panel.
Remove the lower oven door to reduce the weight
of the appliance and to facilitate its handling and its
installation.
To remove the oven door see followin_
1. Open the door to the fully opened position (Figure 4).
2. Pull up the lock located on each hinge toward the front
of range. You may have to apply a little upward pres-
sure on the lock to pull it up (Figure 5).
3. Grasp the door by the sides, pull the bottom of the door
up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while
rotating the top of the door toward the appliance to
completely disengage the hinge levers (Figure 6).
4. Proceed in reverse to replace the oven door. Make
sure the hinge supports are fully engaged before un-
locking the hinge levers.
NOTE: The oven door is very heavy. Be sure to have a
firm grip before lifting the oven door off the hinges. Use
caution once the door is removed. Do not lay door on its
handle. This could cause dents or scratches.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Serial Plate
Location
Lock shown in locked postion
Figure 4
Lock shown unlocked
Figure 5
Figure 6
Hinge Slot - Door removed
from the appliance