Manual

E L I T E
BEFORECALLINGFORSERVICE
To save you time and money, before making a service call check the list below
for any problem you may feel you have with the performance of your oven. If
the problem is something you cannot fix, use the Consumer Service Numbers
located at the back of this manuaf When making any calls, have the Model
No., Serial No., Repair Parts List, Use and Care Guide, and the Date of
Purchase available.
PROBLEM
The display of your
control is flashing "F"
followed by a number
or letter.
POSSIBLE CAUSE
i I !ilJl/11 I
You have a function
error code
J,llll,i, ,., ,,, i_Mml.i ii ilrll,l,ll,,
Oven temperature Oven control calibration,
seems inaccurate.
Oven will not
unlock.
.... i'lllUll,i i iiimllr.............
Clean cycle is not
finished
lUl iii 111111 ,
Oven light does a. Light switch in off
not work. position,
iiiiii ......
Oven did not clean
or results were poor.
b. Oven light bulb
loose or burned out,
a. Controls were not
set properly.
b. Clean cycle was
interrupted,
c. Oven was soiled
heavily.
POSSIBLE SOLUTION
IIIII I II iil,lllg![i/i I
Touch the CLEAR/OFF
pad. Restart the oven.
If the function code
repeats, disconnect all
power to the oven for at
least 30 seconds and then
reconnect power If the
function error code repeats
again, call for service.
I'11! IUI I '1 I
See the temperature
adjustment instructions
following this section.
H L.
Oven !emperature must
drop below the lock
temperature before the
door will unlock
............... i1,'11,'11i H' i I
a. Check oven light
switch on the control
panel,
b. Check the oven
light bulb.
iq i i'11111iiiiii III I
a. Check the self-cleaning
section of this manual
b. The normal clean cycle
should last 4 hours,
20 minutes
c. Heavy spillovers should
be removed before the
cycle is set, You can
also repeat the cycle
31