Owners manual

34
Oven Controls
9. Wipe oven cavity and bottom. Do not clean oven door
gasket (Figure 15). Avoid leaning or resting on the oven door
glass while cleaning cavity.
10. To cancel Steam Clean at any time press STOP.
Notes:
• Opening oven door during Steam Clean cycle prevents the
water from reaching the temperature needed to clean.
• For best results, clean oven immediately after the cycle is
complete. Steam clean works best for soils on the oven
bottom.
• Place a paper towel or cloth in front of the oven to capture
any water that may spill while wiping out.
• A non abrasive scouring pad, stainless steel sponge, plastic
scraper, or eraser style cleaning pad (without cleaner) can
be used for difficult soils. Moisten pads with water before
use.
• Do not leave the residual water in the oven for any length
of time.
• Some condensation or water vapor may appear close to the
oven vent. This is normal. The oven gasket may become
damp; do not wipe dry.
• Local water sources often contain minerals (hard water). If
hard water deposits occur, wipe cavity with a 50/50
solution of water and vinegar or 50/50 solution of lemon
juice and water.
• Steam clean cannot be programmed with a delay start.
• If Steam Clean results are not satisfactory, run a Self Clean.
See “Setting Self Clean” on page 32.
Operating Oven Light
The oven light will automatically turn on when the oven door is
opened.
Press LIGHT to turn the oven light on or off whenever the oven
door is closed. The oven light will not operate during the self
clean operation.
The oven light is located at the upper left rear wall of the oven
interior and is covered with a glass shield held in place by a
wire holder. The glass shield protects the bulb from high tem-
peratures and should always be in place when the oven is in
use.
To replace the interior oven light, see “” on page 39.
Figure 15: Clean around the oven door gasket