Installation Guide

INSTALLING THE RANGE

TEST RUN

Check if the range is properly installed and run a test cycle.

1. Touch Clear/O to start test.

2. Set the elements to Hi to check that the surface heating

elements are working properly. The elements should glow

red and radiate heat, and they should cycle on and

o periodically evenwhen set to theHi position. This

cycling prevents the glass-ceramic from being cracked

by thermal shock.

IMPORTANT: The warm zone does not consume enough

power to glow red.

3. After checking all the surface heating elements, check

the locking system by touching Start for three seconds.

The oven door should lock and the cooktop should not

operate while the Lockout function is turned on. touch

Start for three seconds to disable Lockout.

4. Now check the ovens' operation. Touch Bake and touch

the number keys to set the upper oven temperature to

350°F. Repeat for the lower oven.

5.Theovensshouldnishpreheatingin15minutes,andthe

convection fan should operate while the lower oven is

preheating.

6. After checking the ovens' operation, turn the temperature

up to 450°F and leave the ovens on for at least an hour

to help remove any oil which might cause smoke and

odorswhenrstusingtheovens.

Smokemay come out of the range when it is rst

used.

NOTE