Installation Guide

PREPARING FOR INSTALLATION
5
ENGLISH
BEFORE YOU BEGIN
Remove all tape and packing materials before using the range.
Dispose of all plastic bags after unpacking the range.
Never allow children to play with packing materials.
You can download the installation and owner’s manual at:
http://www.kenmore.com
• The information in this manual should be followed
exactly to avoid a fire or electric shock which may
result in property damage, personal injury, or death.
WARNING
Tip - Over Hazard
A child or adult can tip the range and be
killed. Verify the anti-tip bracket has been
installed. Ensure the anti-tip bracket is
engaged when the range is moved.
Do not operate the range without the anti-
tip bracket in place. Failure to follow these
instructions can result in death or serious
burns to children and adults.
WARNING
bracket
Leveling
leg
bracket
Leveling
leg
To check visually that leveling leg is inserted into
bracket, grasp the top rear edge of the range
and carefully attempt to tilt it forward.
• Wear gloves during the installation procedure.
− Failure to do so can result in bodily injury.
Keep these instructions with your Use & Care Guide for
future reference.
• As when using any appliance generating heat, there
are certain safety precautions you should follow.
• Be sure your range is installed and grounded properly
by a qualified installer or service technician.
• Make sure the wall coverings around the range can
withstand the heat generated by the range.
• To eliminate the need to reach over the surface
elements, cabinet storage space above the elements
should be avoided.
CAUTION
• Read all instructions contained in these installation
instructions before installing range.
• Remove all tape and packing materials from the
oven compartments before connecting the electrical
supply to the range.
• Observe all governing codes and ordinances.
• Be sure to leave these instructions with the consumer.
• Dispose of all plastic bags after unpacking the range.
Never allow children to play with packing materials.
• You can download the Installation Guide and Use &
Care Guide at: www.kenmore.com
NOTE
TOOLS NEEDED
Phillips Screwdriver
Pliers
Tape Measure
Pencil
1
/
4
” Nut Driver
Flat-blade
Screwdriver
Level
Adjustable Wrench
Safety Glasses
Gloves
Drill
PARTS PROVIDED
Template (1)
(For Anti-Tip Bracket Mounted on
Concrete Floors and Walls)
Anchor Sleeves (4)
Anti-Tip Bracket Kit (1)
Lag Bolts (4)
PARTS NOT PROVIDED
(UL Approved 40 or 50 AMP)
4-Wire Cord
OR
3-Wire Cord
Strain Relief
(For Conduit
Installations Only)
PREPARING FOR INSTALLATION