Installation Guide

Choose Attachment Option

IMPORTANT: The dishwasher must be secured to the cabinet as

one of the final steps. Prepare the dishwasher for this by

attaching the two brackets found in the parts bag to the

dishwasher.

For countertops that are wood, laminate, or another similar

surface, use Option A.

For countertops that are marble, granite, or another hard

surface, use Option B.

Option A, Countertop Attachment

Remove the brackets from the package and insert into the open

slots on the left-hand and right-hand top of the dishwasher

collar, as shown.

Using a pair of pliers, bend the tab down to secure the bracket

in place. Repeat this step for the other side.

NOTE: Do not attach the dishwasher. This will be done later.

Option B, Dishwasher Side Attachment

NOTE: Remove the brackets from the parts package.

Break off the end of the bracket along the scored line.

With another person holding the rear of the dishwasher to keep

it from tipping, open dishwasher door and place towel over

pump assembly and spray arm of dishwasher. This will keep

screws from falling into pump area when you are securing

dishwasher to cabinet.

Push the plastic buttons out of the side of the tub.

NOTE: Save the buttons to cover the holes after dishwasher is

installed.

Push bracket into slot on the side of dishwasher, and bend tab in

toward the side of the dishwasher so that it keeps the bracket in

place. Repeat this step for the other side of the dishwasher.

NOTE: Do not attach the dishwasher. This will be done later.

Prepare Water Supply Line

Copper tubing only: Slide nut, and then ferrule about 1" (2.5 cm)

onto copper tubing.

NOTE: To avoid vibration during operation, route the water

supply line so that it does not touch the dishwasher base, frame

or motor.