Installation Guide

Place the small drain hose clamp onto the small end of the drain

hose. Push the new drain hose into the rubber drain hose

connector up to the drain hose stop.

Using pliers, squeeze open the small drain hose clamp and slide

onto connector between stops.

After hose is connected, remove towel.

Make Direct Wire Electrical Connection

NOTE: If the power cord was connected earlier, proceed to

“Secure Dishwasher in Cabinet Opening” section.

Option B, Direct Wire

Install a UL Listed/CSA Approved metallic strain relief. See the

“Tools and Parts” section at the front of the guide for part

details and orders.

Route cable so that it does not touch dishwasher motor or lower

part of dishwasher tub. Pull cable through UL Listed/CSA

Approved strain relief in terminal box.

Note: A maximum of two field wiring supply conductors

(12 AWG largest size) plus one grounding conductor are

permitted in the terminal box.