Manual

Setting Surface Burner Controls

Setting the Turbo Boil Flex Twin Burner

The versatile Turbo Boil Flex Twin burner offers a complete

range of gas surface settings from the same burner position.

At the lowest setting, only the burner's inner ring is active,

providing a smaller flame that is perfect for simmering. If

needed, the burner's outer ring may be added and when set

for HI will provide a gas flame that may be used to bring a

large pan of liquid to boil quickly.

Operating the Turbo Boil Flex Twin Burner

1. Place cooking utensil on surface burner.

2. Push the surface control knob down and turn

counterclockwise out of the OFF position (See Figure 1).

3. Release the knob and rotate to the Life position.

4. Visually check that both the inner and outer rings for

the Twin burner are lit (See Figure 3). Once lit, turn the

control knob and continue to turn counterclockwise out

of the Lite position and adjust to the desired flame size.

5. When adjusting for a low or simmer type flame setting,

continue to rotate the control knob counterclockwise

from middle setting towards Lo (See Figure 1). Between

the middle and Lo settings, the flame for the outer ring

portion of the burner will turn off: leaving only the inner

burner with a flame for simmering (See Figure 4). Make

any further flame adjustments as needed.

Figure 2 - Twin Burner

Figure 3 - Inner and Outer rings lit

Figure 4 - Inner ring only lit

OFF Life Hi

Figure 1 - Twin Burner Control

Important nares:

° DO NOT cool< with the surface control knob left in the

LITE position. (The electronic ignitor will continue to spark

if the control knob setting remains in the LITE position).

° When setting any surface control knob to the LITE

position, all electronic surface ignitors will spark at the

same time. However, only the surface burner you are

setting will ignite.

° NEVER place or straddle a cooking utensil over two

different surface cooking areas at the same time. This

can cause uneven heating results.